Vingtor SP-5T User manual
TECHNICAL & USER MANUAL
SP-5T
Common Line Intercom System
A100K10870
2A100K10870
SP-5T Technical & User Manual
About this Document
Document Scope
This document describes the system features, available
equipment, typical congurations, simplied wiring and technical
specications for the SP-5T Common Line Intercom System.
Publication Log
Rev. Date Author Comments
0.0 2002.05.07 SEN First release Zenitel Marine. main units with
new circuit, balanced output. Ver. 01
0.1 2002.08.20 SEN
Documents for Ver. 02 in addition SP-5MT
& HT with new PCB. Type VP1207 (Ecas)
same function.
1.0 2010.08.25 SEN
New front and back page, new datasheets
Doc.no. SP-5T_ut Rev.01 is replaced by
document no. A100K10870
1.1 2011.04.11 HKL
Handheld mic type H66-SP5
Headset type SP5-36-PELP
Proofread and converted all contents into
Indesign format
Related Documentation
Documentation Doc. no.
Datasheet - SP-5MT A100K10948
Datasheet - SP-5HT A100K10947
Datasheet - SP-36-PELP A100K10949
Datasheet - H66-SP5 A100K10944
Datasheet - Power Amplier VPA-120 A100K10504
Datasheet - Power Amplier VPA-240 A100K10505
Datasheet - Power Amplier VPA-400 A100K10506
Datasheet - Amplier Rack RS-3C A100K10711
Cable Connection Diagram - SP-5T SP-5T_cc_wd
Cable Connection Diagram - SP-5T Ver. 02 SP-5T Ver.02_cc_wd
Wiring Diagram - Amplier Rack RS-3C RS-3C_wd rev.02
Installation & User Manual - VPA-120/VPA-240/VPA-400 A100K10875
Zenitel Norway AS and its subsidiaries assume no responsibilities for any errors that may appear in this
publication, or for damages arising from the information in it. No information in this publication should be
regarded as a warranty by Zenitel Norway AS.
The information in this publication may be updated or changed without notice. Product names mentioned in
this publication may be trademarks and are used only for identication.
Zenitel Norway AS © 2011
SP-5T Technical & User Manual
A100K10870 3
Contents
1 General Description .........................................................................4
2 Installation Instructions...................................................................5
2.1 General .....................................................................................5
2.2 Cable Requirements .................................................................5
2.3 Level Adjustment .......................................................................5
3 User Instructions..............................................................................6
4 Connection Diagrams & Dimension Drawings..............................7
4.1 SP-5T Ver. 02 Cable Connection Diagram ...............................7
4.2 SP-5T Cable Connection Diagram ............................................8
4.3 SP-5MT Microphone Station .....................................................9
4.4 SP-5HT Microphone Station .....................................................9
4.5 SP5-36-PELP Headset ...........................................................10
4.6 H66-SP5 Handheld Microphone .............................................10
5 Specications................................................................................. 11
5.1 SP-5MT Microphone Station ................................................... 11
5.2 SP-5HT Microphone Station ................................................... 11
5.3 SP5-36-PELP Headset ........................................................... 11
5.4 H66-SP5 Handheld Microphone ............................................. 11
4A100K10870
SP-5T Technical & User Manual
General Description1
The SP-5T Common Line Intercom System provides All-to-All
communication between a specied numbers of microphone or
headset stations.
The number of stations that can be connected depends on output
power and loudspeaker tapping.
Note that product versions 01 & 02 have the same functions, exceptL
they have different PCBs.
The system consists of :
Watertight Microphone station, type SP-5MT ●
for handheld microphone, type H66-SP5-
Watertight Microphone station, type SP-5HT●
for headset with boom-microphone, type SP5-36-PELP-
100V line loudspeaker for each station●
Rack, type RS-3C with VPA-120, VPA-240, or VPA-400 power ●
amplier
SP-5T Technical & User Manual
A100K10870 5
Installation Instructions2
General2.1
For proper installation and operation of the SP-5T system, we
recommend reading this section thoroughly together with the
installation drawings.
Make sure that all mounting and cabling are correct before
switching the system on.
The amplier rack and power supply is for installation indoors
while the weatherproof and rugged microphone stations and
loudspeakers are for outdoor use.
AmplierrackRS-3C/VPA
The amplier rack and power supply should be mounted in a
normal and ventilated indoor environment with a temperature of
0 - 55 ˚C.
It is equipped with screw terminals for cables with a maximum
length of 2.5 mm2.
MicrophonestationtypeSP-5MT&HeadsetstationtypeSP-5HT
The Microphone/Headset stations and loudspeakers are
weatherproof and designed for outdoor use. It is equipped with
screw terminals for cables with a maximum length of 2.5 mm2.
Caution: Use separate cables for input and output signals.L
Cable Requirements2.2
All signal cables have to be approved ship cables with twisted
pair at a minimum of 2 x 0.75 mm2 and outer screen. The screens
must be interconnected in junction boxes and grounded in
terminal X2-1 in amplier rack RS-3C only. They are open in SP-
5T stations.
Note that proper grounding is essential for reliable operation.L
Level Adjustment2.3
Adjust the volume control at the rear of the amplier with a screw
driver until you have a suitable power level. This volume is now
permanently set.
The power amplier VPA-120, VPA-240 or VPA-400 must always
be in the ON position.
6A100K10870
SP-5T Technical & User Manual
User Instructions3
To use the system:
Press the TALK button and speak clearly into the microphone.●
When you press the TALK button and speak into the microphone
or headset microphone from any station, you can be heard in all
other loudspeakers or headsets.
The station’s own loudspeaker will be muted.
SP-5T Technical & User Manual
A100K10870 7
Connection Diagrams & Dimension Drawings4
SP-5TVer.02CableConnectionDiagram4.1
8A100K10870
SP-5T Technical & User Manual
SP-5TCableConnectionDiagram4.2
SP-5T Technical & User Manual
A100K10870 9
SP-5MTMicrophoneStation4.3
SP-5HTMicrophoneStation4.4
VINGTORSERVOTEKNIKK
STEENHANS
Marine
Article No:
SP-5MT
SP-5MT_ds rev.00 2002.05.02
Common Line Intercom System
Description: Technical data:
Mounting holes diam. 6.0 mm
204
82
224
124
63
PG-13 PG-11 PG-11 PG-11 PG-13
SP-5MT
Watertight microphone station with handheld microphone
type H66-SP5
Bulkhead mounting
Balanced output.
For use in the SP-5 Common Line Intercom System and
VMA amplifier system.
Material: Bayblend plastic housing
Colour: Grey
IP rating: IP-65
Dimensions: see dwg. above
Wei ght : 0,9 kg
Operating voltage: 24 Vdc
Loudspeaker output: 100 V, balanced.
Cable requirements: Twisted pair w/ outer
screen, input and output
must be in seperate cable
Connections: Screw terminals for cable
max. 2,5 mm2
Accessories:
Headset H66-SP5, see seperate datasheet
VINGTORSERVOTEKNIKK
STEENHANS
Marine
Article No:
SP-5HT
SP-5HT_ds rev.00 2002.05.02
Common Line Intercom System
Description: Technical data:
Mounting holes diam. 6.0 mm
204
82
224
124
63
PG-13 PG-11 PG-11 PG-11 PG-13
SP-5HT
Watertight microphone station with headset
type SP5-36-PELP
Bulkhead mounting
Balanced output
For use in the SP-5 Common Line Intercom System
Material: Bayblend plastic housing
Colour: Grey
IP rating: IP-65
Dimensions: see dwg. above
Wei ght : 0,9 kg
Operating voltage: 24 Vdc
Loudspeaker output: 100 V balanced
Cable requirements: Twisted pair w/ outer
screen, input and output
must be in seperate cable
Connections: Screw terminals for cable
max. 2,5 mm2
Accessories:
Headset SP5-36-PELP, see separate datasheet
10 A100K10870
SP-5T Technical & User Manual
SP5-36-PELPHeadset4.5
H66-SP5HandheldMicrophone4.6
VINGTORSERVOTEKNIKK
STEENHANS
Marine
Article No:
SP5-36-PELP
SP5-36-PELP_ds rev.01 2002.03.13
Common Line Intercom System
Description: Technical data:
SP5-36-PELP
Headset for connection to a station
Includes TALK switchbox w/ belt clip
Standard with 10 meter cable and plug
To be used in noisy areas
Connections: 7 pin plug
Headset: Peltor MT 7H7A
Colour: Black
IP rating: IP-54
Dimensions: See dwg. above
Weigh t: Approx. 1,2 kg
10m cable 10m cable
110
200
95
55
55
18 38
40
40
60
124
Headset holder
VINGTORSERVOTEKNIKK
STEENHANS
Marine
Article No:
H66-SP5
H66-SP5_ds rev.00 2001.10.02
Common Line Intercom System
Description: Technical data:
Ø 54 54
81
24
52
H66-SP5
Watertight, salt water resistant handheld microphone-
loudspeaker unit
Suitable for heavy-duty outdoor operation subject to noise
disturbance
Delivered with 2 meter flexicable and plug
For use together with SP-5M
Type/art.no.: Holmco 66 / 84-15-06980
DC resistance: 200 ohm
Mic.sensitivity: 0.5 mV/dyne/sq.cm
at 1 kHz
Power capacity: 0.2 W (0.5 W peak)
LS sensitivity: 57 dB/mW at 1 kHz
and 50 cm distance
i.e. 80 dB at 0.2 W audio-
frequency power.
Working temp. -30 to +60 °C
IP class: IP-66
Colour: Black
Dimensions: See dwg. above
Wei ght : 0,3 kg
SP-5T Technical & User Manual
A100K10870 11
Specications5
SP-5MTMicrophoneStation5.1
Material Bayblend plastic housing
Color Grey
IP rating IP-65
Dimensions (WxHxD) 224 x 124 x 63 mm
Weight 0.9 kg
Operating voltage 24V DC
Loudspeaker output 100V, balanced
Cable requirements Twisted pair with outer screen, input and output must be in
separate cables
Connections Screw terminals for cable max. 2.5 mm2
Accessories Handheld microphone H66-SP5
SP-5HTMicrophoneStation5.2
Material Bayblend plastic housing
Color Grey
IP rating IP-65
Dimensions (WxHxD) 224 x 124 x 63 mm
Weight 0.9 kg
Operating voltage 24V DC
Loudspeaker output 100V, balanced
Cable requirements Twisted pair with outer screen, input and output must be in
separate cables
Connections Screw terminals for cable max. 2.5 mm2
Accessories Headset SP5-36-PELP
SP5-36-PELPHeadset5.3
Connections 7-pin plug
Headset Peltor MT 7H7A
Color Black
IP rating IP-54
Weight 1.2 kg
H66-SP5HandheldMicrophone5.4
Type/article no. Holmco 66 / 84-15-06980
DC resistance 200 ohm
Microphone sensitivity 0.5 mV/dyne/sq.cm at 1 kHz
Power capacity 0.2 W (0.5 W peak)
LS sensitivity 57 dB/mW at 1 kHz and 50 cm distance, i.e. 80 dB at
0.2W audio-frequency power
Working temperature -30 to +60 °C
IP rating IP-66
Color Black
Weight 0.3 kg
www.vingtor.com
Zenitel Norway AS
VINGTOR products are developed and marketed by Zenitel Norway AS. The company’s Quality Assurance System is certified to meet the requirements in NS-EN ISO 9001:2008. Zenitel Norway AS reserves the right to modify designs
and alter specifications without prior notice, in pursuance of a policy of continuous improvement. © 2011 Zenitel Norway AS.
support@vingtor.com
DOC NO.
A100K10870
This manual suits for next models
4
Table of contents
