VIORE EXCEL LC32VX60PB User manual

32" HD LCD Television
LC32 VX6

Contents
Safety and warnings ...................................................................................... 2-4
Introduction ................................................................................................. 5
Installation .................................................................................................. 6-9
Remote Control .......................................................................................... 10
Operation .......................................................................................................... 14
Trouble Shooting .......................................................................................... 15

SA FE TYA ND WARNINGS
IMPORTANT SAFETY INSTRUCTION
1.Read these safety instructions.
2.Keep these safety instructions.
3.tIeed all warnings.
4.Follow all safety instructions.
5.Do not use this apparatus near water.
6.Clean only with dry cloth.
7.Do not block any ventilation openings. Install in
accordance with the manufacturers instructions.
_.Do not install near any heat sources such as radiators,
stoves, or other apparatus {including amplifiers)that
produce heat.
9.Protect the power cord from being walked on or
pinched particularly at power outlets, and the point
where they exit from tile apparatus.
10.Only use attachments/accessories specified by the
manufacturer.
11.Unplug this apparatus during lightning storms or
when unused for long periods of time.
12.Re%r all servicing to qualified service personneh
Servicing is required when the apparatus has been
damaged in any way, such as the power-supply cord
or plug is damaged, liquid has been spilled or objects
have fallen into the apparatus, the apparatus has been
exposed to rain or moisture, does not operate normally,
or has been dropped.
13.Apparatus must not be exposed to dripping or
splashing and no objects filled with liquids, such as
vases, should be placed oil the apparatus.
CAUTION
TO REDUCE TIlE RISK OF ELECTRIC SttOCK, DO
NOT REMOVE COVER (OR BACK).NO USER
SERVICEABLE PARTS INSIDE. REFER SERVICING
TO QUALIFIED SERVICE PERSONNEL.
The symbol indicates that dangerous voltages
constituting a risk of electric shock are present
within this miit.
The symbol indicates that there are important
operating and maintenance instructions in the
literature accompanying this unit.
WARNING:
To prevent ['ire or shock hazard, do not expose this
appliance to rain or moisture.
-2-

SAFETYAND WARNINGS
High voltages are used in the operation of tbis television
receiver. Do not remove the cabinet back fi-om your set.
Refer ser,'icing to qualified service personneh
\
To prevent fire or electrical shock hazard, do not expose
the television receiver to rain or moisture.
Do not drop or push objects into the television cabinet
slots or openings. Never spill any kind of liquid on the
television receiver.
Do not block the ventilation holes in the back covet-.
Adequate ventilation is essential to prevent tSlilure of
electrical components.
Do not trap the power supply cord under the television
receiveL
Never stand on, lean on, or suddenly pusb the television or
its stand. You should pay special attention to children.
Serious injury may result if it tails.
Do not place your television on an unstable cart, stand,
shelf or table. Serious injury to an individual, and damage
to the television, may result if it t_llls.
When tbe television receiver is not used for an
extended period of time, it is advisable to disconnect
theAC power cord from theAC outlet.
Avoid exposing the television receiver to direct sunlight
and otber sources of heat. Do not stand the television
receiver directly on other products which give offheat,
e.g. video cassette players and audio amplifiers. Do not
place naked flame sources, such as lighted candles on
the television.
If the television is to be built into a compartment or similar
enclosure, the minimm_ distances nmst be maintained. Heat
build-up can reduce the service life of your television, and
can also be dangerous.
-3-

SAFETYAND WARNINGS
Thank you very much for purchasing this TV. To enjoy
your product from the very beginning, read this manual
carcfldly and keep it handy for easy reference.
INSTALLATION
• Locate tile TV in tile room where light does not strike
the screen directly.
• Total darkness or a reflection oil the picture screen can
cause eyestrain. Soft and indirect lighting is recommended
for comfortable viewing.
• Allow enough space between the TV and the wall to
permit ventilation.
• Axoid extreulely waml locations to prevent possible
damage to the cabinet or premature component failure.
• This TV can be connected to AC ] 00-240 Volts. 50/60 tlz.
Never connect to a DC supply or any other power supply.
• Do not cover the ventilation openings when using the TV.
CAUT1ON
Never tamper with any components inside tile TV. or any
other adjustment controls not mentioned in this manuah
All LCD-TVs are high voltage instruments. When you
clean up dust or water drops on the LCD PANEL or
CABINET. the power cord should be pulled out fronl the
receptacle, then wipe the TV with a dry soft cloth. During
thunder and lighting, unplug the power cord and antenna
cord to prevent damage to your TV. All repairs to this TV
should only be performed by qualified TV service personneh
Earthing connection--- Tile apparatus shall be connected
to MAINS socket outlet with a protective earthing connection o
MAINS plug or appliance coupler of the apparatus is used
as disconnect device, it should remains readily opembleo
Warning: Change or modifications to this unit not expressly
by tile part responsible %r conlpliance could void tile user's
authority to operate tile Equipment.
NOTE:
This equipnlent has been tested and found to conlply with
the linlits for a Class 13digital device, pursuant to Part 15
of the FCC Rules. These linlits are designed to prnvide
reasonable protection against harnlfifl interference ill a
residential installation. This equipnlent generates, uses, and
can radiate radio frcquency energy and, if not installed and
used ill accordance with tile instructions, nlay cause harnlfifl
interference will not occur ill a particular installation. If this
equipment does cause harnlfifl interference to radio or
television reception, which can be determined by turning
the equipment off and oil, the user is encouraged to try to
correct tile interference by nile or more of tile f\)llowing
measures:
- Reorient or relocate tile receiving antenna.
- Increase tile separation between tile equipment and receiver.
- Connect the equipment into an outlet oil a circuit different
fl-om that to which tile receiver is connected.
-Consult tile dealer or an experienced radio TV technician
f\/r help.
Shield cables must be used with this unit to ensure
compliance with the Class 13FCC limits.
_4_

INTROD UCTION
i tbatures
@ Used as Television, display terminal,PC display;
@ ttigh luminance,wide viewing angle;
@ BTSC;
@ ATSC digital signals and NTSC analog signals TV.
AC Power Cord .........................
Infrared Remote Control ...........
User's Manual ........................
Battery(AAA) ..........................
Main parameter
Viewing Picture Size(diagonal) 32incb
Resolution: 1366x768
Aspect Ratio: 16:9
TV System: ATSC Digital system and NTSC Analog system
Video Signal System: NTSC/PALiSECAM
Receiving Cbannel: Cable :1-135/Air: 2-69(ATV&DTV)
Power consumption: 170W
Input Power Voltage: AC 100V-240V 50i60tlz
Audio Output Power(TIlD < 7%): 2xSW
Rear tligb-Definition Multimedia Intertace(tlDMl) Input x 2
Side tIDMI Input x 1
Rear S-Video Input x 1
YCb(Pb)Cr(Pr) Input x 1
Side S-Video Input x 1
Rear Analog Audio Output x 1
Rear Coaxial SPDIF Output x 1
Analog RGB(VGA) Input x 1
Rear Composite Video Input x 1
Rear Audio Input x 3
Side Composite Video Input x
Side tlEAD PIIONE Output x
Rear Composite Video Output x
ltoriz<mtal definitlon(TV llne) Composite Video Input >350
Video Input > 400
YCb(Pb)Cr(Pr) > 400
-5-

INSTALLAITON
(2
@
_) _ SOURCI
CH_
CH
VOL
\. J
!. SOURCE:
Display the input source menu.
2. MENU:
l: Remote control sensor. Display main MENU.
3, CH+/CH-
2: Indicator LED: GREEN POWER ON. In TV mode, press "Ctlq " or "CtI-" to change
RED O STANDBY. the channelup and down.
In MENU mode, press "CtI!" or"CtI-" to select
3: Key board items .
4: Power: Press this button to turn the unit In standby mode, press "Ctt!" or"Ctt-" to turn
on the TV.
ON from STANDBY mode. 4. VOL+/VOL-
Press it again to turn the set back to Adjust sound level.
In MENU mode, press "VOL_ " or "VOL-" to
STANDBY. adjust the item that you selected.
1.ANT 6. YPbPrAUDIO INPUT 11. VGAINPUT
2. AUDIO OUTPUT 7. PCAUDIO INPUT 12. ttDMI2 INPUT
3. SPDIF OUTPUT 8. YPbPr INPUT 13. ttDMI1 INPUT
4. VIDEO OUTPUT 9. AV1 INPUT 14. AC POWER INPUT
5.AV1iS-VIDEO1 AUDIO INPUT 10. S-VIDEO1 INPUT
Note:
1.AV1 and S-VIDEO] share one audio channel.
2. WhentlDMl] port get DVI signal, the "PC Audio" channel will change to receive the audio fromtlDMll port
3. When tlDMl2 port get DVI signal, the "YPbPr Audio" channel will change to receive the audio from tlDMl2 port.
4.AV OUTPUT :
When the source are AV ],AV2{side) S-VI DEO 1,S-VI DEO2{side),ATV, the AV OUTPUT Channel reproduce the input
signals accordingly
-6-

INSTALLATION
STEPS:
Be sure both the TV and computer are set to Power off.
l.Connect VGA and audio cable.
2.Connect the power cord.
3.Power on the TV, switch to VGA mode.
4.Power on the VGA.
This sequence is very important.
#............................................... ........................................:h
/o
PRESET MODE
.i i
RESOLUTION V.Freq.(Hz) H.Freq.(KHz)
1 720*400 70 31.47
2 640*480 60 31.47
3 640*480 72 37.86
4 640*480 75 37.50
5 800*600 56 35.156
6 800*600 60 37.88
7 800*600 72 48.08
8 800*600 75 46.88
9 1024"768 60 48.36
10 1024"768 70 56.48
11 1024"768 75 60.02
12 1280"1024 60 63.98
13 1280"1024 75 80.00
-7-

INS TA L LA TION
:_ NN
e i
iiiiiiiiiiii_iiii{iiii_jiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii_i{ii{iiiiii_iiiiiiiiiiiiiiiiiiiiiiiiiiu_
o o
o o
_:l[ , IIlO
Plug
.m
ANT 75_! \__LEAD FEED ER(300tl) I
Adaptor (NOT SUPPLIED) '_
An outdoor antenna
An indoor antenna
CATV net
.......................................................................L..............................................................................................................................................................................................................................................................................................................................................
Loosen the screws insert the feeder in Wires Tighten the screws
Note:
Aerial connections:IE( (female).
Input impendance:75 t_ unbalanced.
-8-

INSTALLATION
EN
This TV provides two groups of AV ,two S-Video,one group of YPbPr for convenient connection
to VCR,DVD or other video equipment,three group of HDM1 for HD signal input Please refer to
the owner's manual of the equipment to be connected as well.
You can use the input terminals on TV set rear as follows.
;;'2;','2,.......... ,,......................
_y ,_#_ ,_,_, _'
It can be connected to the following appliances: VCR, multi disc player, DVD, camcorder, video game
or stereo system, etc.....
YPbPr can support these video fomats:480i,576i,480p,576p,720p,1080i,1080p.
NOTE:
AV2 and S-V1DEO2 share the audio input channel.
When tlDMI3 port get DVl signal, the "AV2Audio" channel will change to receive the audio
from HDM13 port
-9-