4999DR-167 Rev. 1
Solid State Logic C10 HD
Requirements
• Large Audio Mixer Interface Software Option
• Serial Interface Cables (DB9 to DB9)
Port Connections
Pinouts
Switcher Setup
To Set Up Communications
1. Press HOME Setup Installation Com Setup
Type.
•UsetheCom Port knob to select the REMOTE Xport that
you connected the SSL C10 HD to.
•UsetheDevice knob to select Audio Mixer.
2. Press Select Device.
•UsetheDevice knob to select RAP.
3. Press Com Type.
•UsetheType knob to select RS-422.
4. Press Com Settings.
•UsetheBaud knob to select 115200.
•UsetheParity knob to select ODD.
5. Press Extra Options.
6. Press HOME Confirm.
To Assign Audio Channels to BNCs
1. Press HOME Setup Installation BNC Audio.
2. Use the BNC knob to select the Input BNC that you want to
assign an audio channel to.
3. Use the Audio 1 knob to select an audio channel, or group, that
you want to assign to the selected Input BNC.
4. Use the Audio 2 knob to select another audio channel, or group,
that you want to assign to the selected Input BNC.
5. Press HOME Confirm.
Refer to your switcher manual for information on creating audio
groups, or setting default audio levels.
Device Setup
Ensure the port on the SSL C10 HD that is connected to the switcher
is configured for RS-422. You must enable REMOTE ON in the SSL
console, via the soft-key.
Compatibility
Switcher Audio Mixer
Communications REMOTE Port
(female) RS422 Port
Switcher SSL C10 HD
2 (Rx-) 2 (Tx-)
3 (Tx+) 3 (Rx+)
7 (Rx+) 7 (Tx+)
8 (Tx-) 8 (Rx-)
Extra Options Value
OD Master M1 (default)
TargetMachine Generic
Audio Mixer Version
Solid State Logic C10 HD --
Switchers
Synergy 1 SD --
Synergy Series SD --
Synergy MD/X --
Vision MD/X --
Vision QMD/X 16.0
Vision MultiPanel Support --
Automation
OverDrive 12.0 or higher
Port Expanders
BSS4
Comtrol DeviceMastera
a. You must set Server/Client to Server on the Com
Settings of the Communications Menu 1-2 when
connecting to a Comtrol DeviceMaster.
