VISIONARY DESIGNS MOD-9003 User manual

© 2020
Order #XXXXX
Locked layer contains
placeholder marks.
Graphic Attachment
2) Tighten knob on back of clamp
to secure graphic in place.
1) Insert graphic into clamp.
BACK VIEW
*
*
Completed Assembly
Steps:
1) Attach base plate to bottom of post, using bolt.
2) Connect graphic to A10 clamp on top of post.
See Graphic Attachment detail.
Bolt
Base
Plate
Z-Plate
Graphic
Post
Graphic
Clamp
Knob
Keep Z-plate attached to post when packing.
MOD-9003 Hand Sanitizer Stand
If you would like to tell us about your experience with your setup instructions please email us at [email protected]
SETUP INSTRUCTIONS

© 2020
Order #XXXXX
DO NOT USE POWER TOOLS
DO NOT USE SCREWS
THAT ARE STRIPPED
ALL CONNECTIONS MUST
BE TIGHTLY SECURED
General Setup Instructions
- Read entire setup instruction manual prior to
unpacking parts and pieces.
- The setup instructions are created specifically
for this configuration.
- Setup instructions are laid out sequentially in
steps, including exploded views with detailed
explanation for assembly.
WARNING
Cleaning & Packing
- For Cleaning Metal, Plex, & Laminate Parts:
Use a MILD NON-ABRASIVE cleanser and
soft cloth/paper towel to clean all surfaces.
- Keep exhibit components away from heat
and prolonged sun exposure.
Heat and UV exposure will warp and
fade components.
- Retain all provided Packing Materials.
All provided packing materials are for
ease of repacking & component protection.
Disassembly
- For loss prevention, tighten all set screws
and locks during disassembly.
Hex Tool - Essential for Assembly
General Information