VISIONTRON SSG3012 User manual

Attach Swing Gate panel to hinge
bracket
a) Slide sign panel (A) with pre-drilled holes
into channel of bracket (E).
b) Align sign panel (A) holes with bracket (E)
holes and install hardware: screw (B), lock
washer (C) and cap nut (D).
c) Tighten all hardware.
ASSEMBLY INSTRUCTIONS
Security Swing Gate
Model SSG3012
TOOLS & HARDWARE
ASSEMBLY INSTRUCTIONS
1
Figure 1:
Swing Gate assembly with unleveled sign
If sign is not level, adjust
springs to re-tension. See
side 2 for instructions.
Level
Phillips head screwdriver
7/16" Wrench
3/32" or 3MM Allen Key
(if Adjustment Rod not available)
Not included
Included
D
A
C
B
E
(1) 3/32" Adjustment Rod
(2) #1/4-20 x ¾" PHPH Screw
(2) #1/4-20 Cap Nut
(2) #1/4 Split Lock Washer
(4) Stop Pin (pre-installed in hinges)

SHOULD YOU REQUIRE ASSISTANCE, PLEASE CALL A PEOPLE GUIDANCE PRO AT 631-582-8600.
SIGN LEVEL ADJUSTMENT
11162023
A
B
A
B
A
B
C
Note: Both hinge barrels must be adjusted. We recommend starting with right side (as shown)
2
Rotate adjustment rod (B)
clockwise away from stop
pin (A) to reveal the next
adjustment hole (C).
1Insert adjustment rod (B)
into adjustment hole(C)
just to the left of the
installed
stop pin(A) .
Note: Repeat steps 1-4 until
sign is level. Do not tension
more than 3 extra holes from
factory setting.
4Remove adjustment rod (B)
from adjustment hole (C).
Repeat for other side of
hinge barrel.
3
Relocate the stop pin (A)
to the newly exposed
adjustment hole (C) and
add tension.
C
A
B
C