Vista Apex PinkWave User manual

QUICK START GUIDE
91047-AP-ENG (4)
GETTING STARTED
SETTING A MODE
1. Unpack the contents of the PinkWave™ box:
(1) PinkWave™ cordless handpiece and battery pack, (1) charging base, (1) charging cord,
(5) autoclavable light shields, (100) PinkWave™ Barrier Sleeves and (1) User's Manual.
There will also be (3) pairs of protective eyewear included in your shipment.
2. Plug charger into charging base and plug into wall outlet.
Set PinkWave™ handpiece into the base to charge.
3. The pink ring on the charging base should pulsate, indicating that the light is charging.
The pink ring will turn solid when PinkWave™ is fully charged.
1. Identify the mode button. Use a short press to toggle between settings.
A light will illuminate the setting that is being selected.
3B 3-second Boost Mode
20R 20-second Ramp Mode
20S 20-second Standard Mode
All Transillumintor
3B 20R 20S Transillumintor
NOTE: Low battery indicator light will ash red
when battery reaches 33% battery life available.
NOTE: Setting is memorized as default until charged.
Mode Indicators
3-Second Boost Mode, 20-Second Ramp
Mode or 20-Second Standard Mode
Mode Button
On/O Button
Battery Indicator
= Mode selected
Refer to User’s Manual for detailed instructions.

QUICK START GUIDE
OPERATING LIGHT
TRANSILLUMINATOR
SAFETY AND DISINFECTION
1. Once setting is selected, give one short press on either the front or back
On/O button. This will start the curing cycle that was chosen.
The light will automatically turn o when the curing cycle is complete.
On standard and ramp modes, the device will beep once at 5 seconds,
twice at 10 seconds and three times at 15 seconds.
2. Press On/O to power o at anytime.
1. To switch toTransilluminator mode, use the mode button to select mode 4,
where all lights are illuminated.
2. Press On/O.
1. Always have an autoclavable light shield in place before turning device on.
2. Device may be wiped down with a standard disinfecting wipe.
Refer to User's Manual for full details and sanitizing protocol.
3. Only PinkWave™ Barrier Sleeves should be
used with the PinkWave™ Curing Light.
NOTE: Make sure light shield is in
place before turning on.
NOTE: Light shields are autoclavable. Please reference
your autoclave instructions for sanitizing protocol.
CAUTION: Never spray
disinfectant directly on surface.
CAUTION: DO NOT operate PinkWave™ without the
light shield and Vista Apex provided protective eyewear.
CAUTION: DO NOT operate PinkWave™ without the
light shield and Vista Apex provided protective eyewear.
On/O Button
On/O Button
91047-AP-ENG (4)Refer to User’s Manual for detailed instructions.
vistaapex.com | 262-636-9755 Inside US | 877-418-4782 Outside US and Canada