Vista VFD13C/HR User manual

INSTRUCTION MANUAL
VFD13C/HR Fixed Colour Dome
Thank you for choosing this high quality camera, before attempting to connect or operate this product, please read
and follow these instructions
G
General
This is a Colour CCD video camera employs a 1/3" CCD (charge coupled device) solid-state imaging device which
provide high reliability. This mini dome camera is easily installed in most internal locations along with its very low
current consumption of 100mA the camera is not only simple to install but achieves an excellent reliability record.
Features
1. 480 TV lines of horizontal resolution and high quality picture.
2. Built in Auto Electronic Shutter.
3. Minimum illumination of 1 Lux/F2.0
4. Signal-to-noise ratio of 48dB.
5. Low current consumption of 100mA.
6. Long life and high reliability.
SPECIFICATION
Image sensor 1/3" Colour Super HAD CCD
Number of Pixel 752(H) x 582(V) <PAL>
Resolution 480 TV lines
Min. Illumination 1 Lux / F2.0
S/N Ratio More than 48dB (AGC off)
Electronic Shutter 1/60 (1/50) to 1/100,000 sec.
White Balance Auto white balance
Video Output 1.0Vp-p composite, 75
Standard Board Lens F3.6mm / F2.0
Lens Angle 92°
Colour Rolling Suppress Yes
Iris Mode AES
BLC ON
Gain Control AUTO
Power Source DC12V+ 10%
Current Consumption 100mA
Dimension (mm) 87.5(Ø) x 83(H)
Weight 186g
WARNING:
TO PREVENT FIRE OR ELECTRIC SHOCK HAZARD, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE

Installation & Wiring
1. DC12V Input Terminal: For connected to power supply.
2. Video Output Connector (VIDEO OUT): For connected to video terminal.
Connections
1. Connect to the power cord:
This is to connect camera to a 12V DC regulated power supply.
2. Connect to video input:
This is to connect camera to 75video terminal with standard 75-coaxial cable
Standard Accessories
1. Main Body * 1
2. DC-BNC Connector * 1
3. Instruction Manual * 1
Vista
Norbain House
Eskdale Road
Winnersh Triangle
WOKINGHAM
Berkshire
RG41 5TS
Tel: [phone]
Fax: [phone]
www.vista-cctv.com
1. Please use correct power adaptor, DC12V (regulated), to operate this unit. The power
tolerance of this unit is DC 12V ±10% (DC10.8V~13.2V), over maximum DC13.2V power
input will damage this unit.
2. Video output (BNC connector) of this unit can be only connected to monitor. Please
check the wiring of video output before power on. If the power is offered through video
output, the unit will be damaged.
3. Warning:
To prevent fire or electric shock hazard, do not expose this application to rain or
moisture
CAUTION