
2 3
Phillips
Screwdriver
If you do not understand these directions, or if you have any doubts about the safety of the
installation, please call a qualified technician. Check carefully to make sure there are no missing or
defective parts. Improper installation may cause damage or serious injury. Do not use this product
for any purpose that is not explicitly specified in this manual and do not exceed weight capacity.
We cannot be liable for damage or injury caused by improper mounting, incorrect assembly, or
inappropriate use.
TOOLS NEEDED
ASSEMBLY STEPS
STEP 1
WARNING!
PACKAGE CONTENTS
A (x1)
Mount
B (x1)
Tray
S-A (x4)
ST5.5x19mm
Screw
S-B (x4)
M6x12mm
Screw
S-C (x4)
M6 Lock Washer
S-D (x4)
M6 Washer
DO NOT EXCEED WEIGHT CAPACITY.
Failure to do so may result in serious injury.
11 lbs
(5 kg)
Drill
While holding Mount (A) up to the desktop at least 19mm from the edge, mark drilling locations using
a pencil.
A
STEP 2
Pre-drill 15mm/.59" holes into desktop using 5/32" drill bit. Install two ST5.5x19mm screws (S-A) into
le holes, as shown below, leaving a 5mm gap.
S-A