
2 3
ASSEMBLY STEPS
STEP 2
Hold the Track against the underside of the
desk at the desired location and mark drilling
locations with a pencil. Drill 3/8” (10mm)
deep pilot holes using a 1/8” (or 3mm) drill bit,
then mount the Track to the desk using M5x15
screws (S-A) and Washers (S-B) with a Phillips
screwdriver.
PACKAGE CONTENTS
TOOLS NEEDED
WARNING!
Phillips
Screwdriver
A (x1)
Mount
B(x1)
Wrist Pad
C (x1)
Tray
S-A (x6)
M5x15
S-E (x2)
Bumper
If you do not understand these directions, or if you have any doubts about the safety of the installation,
please call a qualified technician. Check carefully to make sure there are no missing or defective parts.
Improper installation may cause damage or serious injury. Do not use this product for any purpose that is
not explicitly specified in this manual. Do not exceed weight capacity. We cannot be liable for damage or
injury caused by improper mounting, incorrect assembly or inappropriate use.
STEP 1
Place the Mount (A) upside down and
loosen the Lever on the side. Raise and
slide the Arm out from the Track.
4.4 lbs
(2 kg)
DO NOT EXCEED WEIGHT CAPACITY.
Failure to do so may result in serious injury.
WARNING: CHOKING HAZARD
SMALL PARTS - NOT FOR CHILDREN UNDER 3 YEARS. ADULT SUPERVISION IS REQUIRED.
S-D (x2)
M4x12
S-B (x6)
Washer
S-C (x4)
M5x12
STEP 3
Install the Tray (C) to the Mount Arm (A) using M5x12 Screws (S-C) and a Phillips
screwdriver. Slide the Arm (A) into the Track.
STEP 4
Swivel the Mount Arm (A) sideways, then install M4x12 Screws (S-D) and Bumpers (S-E)
into the front corners of the Track using a Phillips screwdriver. Swivel the Arm (A) forward,
remove paper backing from the Wrist Pad (B), then place the Wrist Pad (B) on top of the
Tray (C) near the front edge.
M5x12
M4x12
M5x15
S-A
S-A
S-B
S-B
A
S-C
S-C
C
S-D
S-E
S-D
S-E
A
CB
C
AA
A
Track
Track