Vivotek AJ-002 User manual

Camera 01 Camera 02 Camera 03
Camera 04 Camera 06
Camera 05
Camera 07 Camera 08 Camera 09
X2
VAST
12V DC
AJ-002 Joystick
Quick Installation Guide
The AJ-002 is a USB joystick with HID 3-axis PTZ control, a twist wheel for zoom in/zoom out, and 29 congurable
function buttons for use on a VAST server station.
INTRODUCTION
CONNECTION
• 1x Joystick • 1x Quick Installation Guide
• 1x USB type A to type B cable • 1x power adapter 12V DC / 1A
PACKAGE CONTENTS
Following are the conditions for making the connection:
1. The joystick can either be powered by a DC 12V adaptor or via the USB. If powered by USB, plug the USB cable twice
to the USB port to enable USB power.
2. Connect the included USB cable between the USB ports on the joystick and a VAST server.
KEYPAD DEFINITION
1 2
3 4
5 6
8
28
21 22
24 25
23 7
26 27
9 10
12 13
11
14
15 16
18 19
17
20
Below is the keypad numbering sequence:

VIVOTEK INC.
6F, No.192, Lien-Cheng Rd., Chung-Ho, New Taipei City, 235, Taiwan, R.O.C.
|T:[phone]|F:[phone]|E:[email protected]
VIVOTEK USA, INC.
2050 Ringwood Avenue, San Jose, CA 95131
|T: 408-773-8686 |F: 408-773-8298 |E: [email protected]
VIVOTEK Europe
Randstad 22-133, 1316BW Almere, The Netherlands
T:[phone] E:[email protected]
All specications are subject to change without noice.
Copyright © 2016 VIVOTEK INC. All rights reserved.
Since VAST rev. 1.13, the following keypad functions will be available as the defaults for the joystick.
1 Pan 9 #1 17 #9 25 Pause
2 Patrol 10 #2 18 Cancel/Clear/Esc 26 Play
3 Stop 11 #3 19 #0 27 Speed Up
4 Home 12 #4 20 Enter 28 Speed Down
5Focus Near 13 #5 21 Full Screen
6Focus Far 14 #6 22 Manual recording
7 Snapshot 15 #7 23 Change Layout
8 Preset 16 #8 24 Rewind
If you prefer to assign different functions for the keypad, enter the LiveClient, and nd the associated conguration in
Client Settings > Joystick Settings.
Note that the RS232/485 terminal connection is currently not supported.
1. Avoid spilling water onto the device. Avoid using this device in a high-moisture environment.
2. This device should be operated in the indoor environment.
3. When the temperature is lower than -10ºC, the LCD panel may not function normally.
4. If the included power adapter should be replaced, use a 9-15V/1000mA alternative.
5. Avoid impact to the device.
6. This product is manufactured to comply with the requirements of the following directives: 89/336/EEC, 92/31/EEC,
93/68/EEC.
NOTE: