Vixen Horns VXH1168CX2 User manual

VXH1168CX2
INSTALLATION GUIDE
PAGE 1 of 2
BEFORE BEGINNING YOUR INSTALLATION
Read through the whole instruction guide before getting started with the installation. Professional installation is
recommended for this product.
CONTENTS
Single Trumpet Horn (Chrome Plated) with Weather Cover x 2
12V Solenoid with Push to Connect Fitting x 2
3/8” OD Air Line x 2
Mounting Hardware
SAFETY INSTRUCTIONS
Avoid dismantling this horn’s electrical elements.
Avoid touching compressor components with your bare hands immediately after or during use.
Avoid setting up any parts of the horn where there is a risk of falling off or risk of coming in contact with water.
Avoid reaching out to touch or pick up any fallen or water submerged parts.
Set the horn up for use only in areas with adequate ventilation.
Avoid sounding the air horn when in close range to your ear(s) or the ear(s) of others.
Make sure your battery ground is detached before getting your installation started.
Employ equipment for eye protection during drill operations.
Ensure that your air system has no pressure before starting the installation.
The specific voltage requirement for this horn is 12 volt DC, therefore installation must be done to a DC power
source of 12 volts.
MOUNTING
Identify a suitable area for mounting, preferably an unobstructed sheet-metal surface like the frame or body of
the vehicle so as to provide a firm platform which will help protect the horn from damage due to excessive
shaking. Do not attach the horn to any plastic or other flexible material.
Using the back bracket as a guide estimate and mark the positions for the holes, then perforate to size using
a drill.
Move the support bracket towards the trumpet's opening until is tight, then mark the hole and drill.
Use the provided mounting hardware to fasten the horn.

VXH1168CX2
INSTALLATION GUIDE
PAGE 2 of 2
WEATHER COVER
Your horns comes with weather covers, we suggest that you use them at all times as it protect internal parts
of the trumpet.
AIR LINE INSTALLATION
Using the provided 3/8" OD air line, cut the size needed.
Push hose into the solenoid's push to connect fitting.
Connect the other end of the air line to the fitting on your air supply.
If you need to disconnect the air line from the solenoid pull away the air line while pushing the plastic part of
the pneumatic fitting.
Repeat the steps above to connect the second solenoid to the air supply.
ELECTRICAL CONNECTIONS
Join one wire from one solenoid with one wire from the second solenoid, this will be the positive lead and
must be connected to the positive (+) terminal of the battery or alternator. WARNING: We highly recommend
that you use a 20A fuse (not provided) to assure that the circuit remains safe and will not be damaged by
excess current.
Join the remaining wire of one of the solenoids with the remaining wire of the second solenoid, this will be
your negative lead and must be connected to one of the terminals on the horn button.
Ground the other terminal on the horn button by wiring it to bare metal.