Vixen Horns VXS4006 User manual

VXS4006
INSTALLATION GUIDE
PAGE 1 of 2
BEFORE BEGINNING YOUR INSTALLATION
Read through the entire instruction guide before getting started with the installation. Professional installation is
recommended for this product.
CONTENTS
12V Motor Driven Electric Siren (Grey)
SAFETY INSTRUCTIONS
This product produces a very loud sound. Hearing loss or permanent damage may result from improper use.
Do not operate in a closed environment or near pedestrians.
Do not connect the siren to any power source other than that specified above.
MOUNTING
Identify a suitable area for mounting, preferably an unobstructed sheet-metal surface like the frame or body of
the vehicle so as to provide a firm platform which will help protect the siren from damage due to excessive
shaking. Do not attach the siren to any plastic or other flexible material.
Using the bracket as a guide estimate and mark the positions for the holes and then perforate to size using a
drill.
Attach the siren to the vehicle using two screws (not provided).
Adjust the vertical angle of the siren using the two screws on each side.
The specific voltage requirement for this siren is 12 volt DC. Therefore installation must be done
with a DC power source of 12 volts.

VXS4006
INSTALLATION GUIDE
PAGE 2 of 2
ELECTRICAL CONNECTIONS
Connect the positive (RED) wire of the siren to your vehicle's power source and ground the negative (BLACK)
wire of the siren.
To activate the siren install a switch (not included) on the ground cable. If you are installing the siren as part
of an anti-theft alarm system please follow your device’s instructions.
We highly recommend that you use a 10A fuse (not provided) to assure that the circuit remains safe and will
not be damaged by excess current.