Vixen Horns VXS7910 User manual

VXS7910
INSTALLATION GUIDE
PAGE 1 of 2
BEFORE BEGINNING YOUR INSTALLATION
Read through the instruction guide before getting started with the installation. Professional installation is recommended for
this product.
CONTENTS
5-Sound Control Box (Model: CJB100)
100W Speaker
PA Microphone with Bracket
Double Sided Pads
SAFETY INSTRUCTIONS
Make sure you never attempt to disassemble this horn kit’s electrical components.
Avoid operating this product in an area with risk of falling or submergence into a liquid (water).
Make sure you set up in areas with good ventilation.
Never sound the air horn anywhere near your ear(s) or that of another person.
Make sure your battery ground is detached before getting your installation started.
Employ equipment for eye protection during drilling operations.
Do not replace your vehicle's factory horn with this unit or use it as a warning device.
The specific voltage requirement for this horn kit is 12 volt DC, therefore installation must be done to a DC power
source of 12 volts.
MOUNTING
CONTROL BOX
Find a mounting location in which you will have access to the buttons, knob and connectors of the control
box.
Mount the unit on the location chosen with the provided double sided pads.
SPEAKER
The ideal location for the speaker to be installed is a dry area inside your engine compartment where it will be
safe from exhaust and engine manifold heat.
To make the speaker firm and secure use the mounting bracket as a template to mark the holes location and
drill using a 1/8" drill bit.
Secure speaker with four self-tapping screws (not provided).
IMPORTANT: The downward orientation of the speaker will prevent water to get inside.

VXS7910
INSTALLATION GUIDE
PAGE 2 of 2
ELECTRICAL CONNECTIONS
SPEAKER CABLE (GREEN): Route both cables through the fire wall of your vehicle to attach it to the
speaker previously installed in the engine compartment.
MICROPHONE (MIC): To use the unit as a PA system, connect the microphone's cable plug to the control
box.
POWER CABLE (RED/BLACK): Connect the positive wire (Red) to a power source in the vehicle that only
gets power when the vehicle’s ignition is on. Recommended connection points are: windshield wiper motor,
blower motor or an accessory terminal on the fuse panel. Use a 5A fuse (not provided) on this connection for
circuit’s protection. Connect the negative wire (Black) to ground, any rust and paint free metal body bolt or the
negative (-) battery post.
OPERATION
To start using the electronic horn set the vehicle's ignition to the ON position.
OFF: Turning the KNOB clockwise will increase the volume, while moving it counter clockwise will decrease it.
MODES:
oWAIL-2: Press this button to produce a “Wailing” sound.
oWAIL-1: Press this button to produce a “Wailing” sound.
oHI-LO: Press this button to produce a two-tone “HI-LO” sound.
oHORN: Press this button to produce a “Horn” sound.
oSIREN: Press this button to produce a “Siren” sound.
oMIC: Make sure the microphone cable is connected to the control box, pressing the button located on
the left side of the microphone will start broadcasting your voice, release the button to stop
broadcasting.