Viz-Art Automation LEADER Mount User manual

LIST OF ITEMS:
Projector mount:
Universal projector adapter
Adjusted arm (mount with arm)
Mounting set
Installation manual
Mounting template
1. Installation:
A. Prepare an installation place and mark mounting points
using installation template as below:
Install mount to the ceiling
B. Install projector on universal projector adapter. Use
mounting screws from mounting set.
Warning! To connect the mount with the projector, select
the appropriate screws from the mounting kit according to
the recommendations of the projector manufacturer.
C. Joint adapter with installed projector with projector mount
as described below using middle hanger. Block projector on
a mount with screws in holes A.
D. Check and adjust proper projected image. If needed
adjust projector image on a ceiling mount.
LEADER Mount
Universal projector mount:
•Direct
•Adjusted 48 –74
•Adjusted 66 –110
•Adjusted 120 - 200
1/2

2. Adjusting projector on a ceiling mount:
A. Adjusting height of installed projector: Loosen screw B and
adjust expected height of projector. Tighten screw- B. In
Direct Mount height is non adjustable
B. Image adjustment.
If projected image is to low or high on the screen/vertical
distortion/Loosen screws C and tilt projector to expected
vertical position. Tighten screws C, when finished.
C. Projector adjustment.
If projected image is to right or left on the
screen/horizontal distortion/,–rotate projector on a screw
D.
D. Horizontal / parallel image from the projector
adjustment.
Loosen screws E. then adjust the projector mount’s roll
adjustment such that the top and bottom edges of the
image are approximately horizontal and aligned with
the top and bottom of the screen. Tighten screws E,
when finished.
3. Technical Specification:
Product model:
LEADER Mount
Adjustment:
Up-down 15 degrees
Right-left 15 degrees
Horizontal 18 degrees
Tilt 56 degrees (with heigts)
Weight:
LEADER Mount direct 1,1 kg
LEADER Mount 48 -74 with heigts 3 kg
LEADER Mount 66-110 with heigts 4 kg
LEADER Mount 120-200 with heigts 6,5 kg
4. Mounting kit set :
Bolts:
M4x12 –4 pcs.;
M5x12 –8 pcs.;
M6x12 –4 pcs.;
Washers:
ø6x12 – 8 pcs.;
ø5x10 – 4 pcs.;
Wall plugs:
ø8x40 – 4 pcs.;
Screws:
ø5x40 flat head –4 pcs.;
manufactured: VIZ-ART Automation
tel.[phone] www.viz-art.eu
2/2