Voda Plumbingware Ecomix VECM020 User manual

9 421027 594821
Ecomix Cast Spout Basin Mixer
VECM020
Voda Plumbingware Limited | Freephone: 0508 367 366 | 5 Hewlett Street, Port Whangarei 0110 | vodaplumbingware.co.nz
Congratulations on your purchase of this high quality product from Voda Plumbingware.
Please read the following before installation and retain (along with your receipt) for future reference.
TECHNICAL SPECIFICATIONS
Suitable for All Pressures
Minimum Pressure = 17kPa
Maximum operating Pressure = 500kPa
Maximum operating Temperature = 65 deg. Celsius
For domestic use only.
CONFIGURATION
Mains Pressure systems Remove the valve insert from the valve nipple and change aerator to the WELS rated one
supplied.
Unequal Low systems Ensure the valve nipple is attached to the cold in-feed hose (flow arrow aligned to the
water flow).
Equal Low systems Remove the all valve insert from the valve nipples.
INSTALLATION
For pressures exceeding 500kPa, install a pressure limiting valve. Failure to do so may void the warranty.
• Before commencing installation turn o the water supply.
• Position tap in 35mm hole, making sure the seal between tap and supporting surface is in place.
• Anchor to bench with fittings pack.
• Where applicable, it is important to ensure the base ring is hand-tight on the mixer, prior to installation.
• Thoroughly flush all pipes to eliminate any remaining dirt and residue and install inline filters.
• Connect supply hoses to plumbing connections. Minimum bend for flexible hose is 35mm radius.
Do not stretch, crush or twist hoses. Do not swage hose ends.
• Turn on mains supply.
• Check for leaks.
Plumbers Note: Do not pressure test this mixer under static pressure.

WARRANTY
Please refer to our website for warranty information: www.vodaplumbingware.co.nz/warranty
In the unlikely event that this product fails during its warranty period, phone our Customer Service team
immediately on 0508 367 366 – as unauthorised removal of the product may void the warranty.
CARE AND MAINTENANCE
When cleaning this product (including chrome, stainless steel, coloured or any other surface coating) you must not
use any type of astringent, abrasive or citric cleaners.
We recommend using only a so, damp cloth and on occasion a mild soap solution. Try to avoid excessive
scrubbing as this could cause damage and void your warranty.
ATTACH PROOF OF PURCHASE HERE
Voda Plumbingware Limited | Freephone: 0508 367 366 | 5 Hewlett Street, Port Whangarei 0110 | vodaplumbingware.co.nz