VoIP Much Phone Company HT-286 Manual

Copyright VoIP Much Phone Company Inc., 2015
Grandstream Gateways & ATA’s
HT-286, 502, 503, 701, 702, 704, GWX-4008 & 4004
Admin Guide
-MANUAL CONFIGURATION

Copyright VoIP Much Phone Company Inc., 2015
Find the IP Address
Quick Steps
1. Lift the handset of the phone connected to your ATA, Dial *** to initiate the IVR
Menu
2. Wait to be instructed to enter your command.
3. Dial 02 and the IP address will be played to you.
MANUAL CONFIGURATION
Quick Steps
1. Find the IP address of the device and open a web browser to the IP address.
2. Login with the device admin password. Default factory password is admin

Copyright VoIP Much Phone Company Inc., 2015
3. Click on the “Basic Settings” option at the top.
Your telephones receive their time from the ATA device. Be sure you select the
correct time zone below and enter NTP server value (in Advanced Settings):
Click Apply.

Copyright VoIP Much Phone Company Inc., 2015
4. Click on the “Advanced Settings” option at the top.
To prevent your ATA device from receiving direct IP calls (calls not originating
through VoIP Much), set the following option to Yes:
Disable Direct IP Call = Yes
Your telephones receive their time from the ATA device. Be sure you set the
correct time zone (in Basic Settings) and the below NTP server value:
NTP Server: ca.pool.ntp.org
Click Apply

Copyright VoIP Much Phone Company Inc., 2015
5. Click on the “FXS Port” option at the top
The below values can be found in your VoIP Much activation notification.
Primary SIP Server = SIP Server Address
SIP User ID = ATA Device Username (not your phone#)
Authenticate ID = ATA Device Username (not your phone#)
Authenticate Password = ATA Device Password (the long one)

Copyright VoIP Much Phone Company Inc., 2015
Although port 5060 (the default SIP port) should work fine for most… to avoid
issues with some routers and SIP ALG, we recommend using the following
port values:
Local SIP port: 25060
Local RTP port: 25004
To prevent your ATA device from receiving direct IP calls (calls not originating
through VoIP Much), set the following option to Yes:
Allow Incoming SIP Messages from SIP Proxy Only = Yes

Copyright VoIP Much Phone Company Inc., 2015
The remaining settings on this page remain at their default values.
Click Apply.
6. Click Reboot
Your ATA will reboot and register to the VoIP Much network.
Reboot time can be approx. 1 to 2 minutes.