Vonci BT-270B2 User manual

VONCI Commercial Induction Cooker
User Manual
Welcome to be the owner of VONCI induction cooker
Thanks for purchasing a VONCI product. This is the perfect
countertop burner for you! Please make sure that you have read
this user manual before using it. Please keep this manual
properly for reference at any time in the future. If you have
questions or need assistance about this cooker, please don’t
hesitate to email us. We will provide the best service for you.
Email：V[email protected]
Website: https://www.nenwell.com/
The VONCI Support Team
Ⅰ.Specification
1) Brand: VONCI
2) Supplier No.: BT-270B2
3) Item No.: VC-ICBS1-BT18W
4) Power Rate: 500W - 1800W
5) Voltage: 120V ~ / 60Hz
6) Temperature: 140℉-460℉
Ⅱ.Select Appropriate Mode That Satisfy Your Cooking Masks
1) If a specific cooking temperature is not required, we suggest using
Power Mode instead of Temperature Mode. To quickly bring a pot of
water to boil, use a higher power level setting. Similarly, for milk
heating , sauce cooking, etc., the Power Mode is also applicable.
2) For frying or sauteing food, Temperature Mode is preferred because
the built-in microprocessor monitors and regulates the cookware
temperature to the preset temperature.
3) If there is no cookware or an incompatible cookware is used, the
induction cooker will not detect the cookware and will beep. It should
be replaced with a compatible cookware as soon as possible,
otherwise it will automatically shut down after 1 minute.
Ⅲ.Usable and Non-usable Utensils
Please put a small household magnet on the bottom of the cookware, if the
magnet holds, the cookware is compatible. Cookware makes from cast iron, iron,
enameled steel or iron, or magnetic stainless steel work very well. If the
induction cooker does not work or beeps, it is usually caused by using a pan
with a non-magnetic bottom. In this case, please replace a pan with a magnetic
bottom.

1). Usable Pans
Steel or cast iron, enameled iron, stainless steel with a magnetic bottom,
flat-bottom pans / pots with diameter from 12 to 26cm.
Enameled Iron Iron or Enameled Castiron Pan Iron Pot Deep-Fry Pan Stainless Steel Pot Iron Plate
Pot Iron Pot
2). Non-usable Pans
Non-magnetic stainless steel (18/10,18/8) bottom, Heat-resistant glass,
ceramic container, copper, aluminum pans/pots, rounded-bottom pans/pots
with bottom measuring less than 12cm.
Rounded Bottom Aluminum Bottom Measuring Pot with Stands Ceramic Pot Heat-Resistant
Pot Copper Pot Less than 12cm Glass Pot
Ⅳ. Importance
Please read carefully the following instructions before using
the induction cooker.
1). Do not plug with wet hands in order to avoid getting electric shock.
2). Do not plug into a socket where several other appliances are plugged in.
3). Do not use if the power cord is damaged or the plug does not fit the socket
safely.
4). Do not open the cooker to replace spare parts by yourself.
5). Do not use the cooker closed to flame or wet places.
6). Do not use where children can easily touch the cooker, or allow children to
use the cooker by themselves.
7). Do not place on unstable surfaces.
8). Do not move the cooker together with a pot.
9). Do not heat a pot empty or overheat to avoid dry boiling.
10). Do not place metallic objects such as knives, forks, spoons, lids, cans,
and aluminum foils on the top plate.
11). Use the unit with sufficient space around it. Keep the front side and either
right or left side of the unit clear.
12). Do not use the unit on carpet or tablecloth (vinyl) or any other
low-heat-resistant article.
13). Do not place a sheet of paper between the pot or the pan and the unit. The
paper may get burnt.
14). If the surface is cracked, switch off and take to the service center
immediately.
15). Do not block air intake or exhaust vent.
16). Do not touch the top plate right after removing the pot or the pan, as the
top plate will still be very hot.
17). Do not place the cooker close to the objects which are affected by magnet,
such as: radios, televisions, automatic-banking cards or cassette tapes.
18). The power cord must be replaced by qualified technicians.
19). Stands for the surface is liable to get hot during use.
V.How to Use
1). Please put suitable cookware onto the plate of induction cooker, and
connect the plug to suitable socket.
2).After connected, the light of Power will shine, indicating that the power is
connected normally.Pressing button, the light of Heating will shine,
indicating that the induction cooker is entering the state of Power is
1200W. Adjust the power rate from level 500-1800 by adjust the “+ ”or “-”
button
3). Pressing button, the light of Keep temp will shine, indicating the
induction cooker is entering the state of keeping temperature, the default

temperature is 250F, Adjust the temperature from 140F to 460F by
turning the “+ ”or “-” button.
4). Adjust the time from 0 minute to 170 minutes by “+ ”or “-” ,The time is
displayed as five minutes in each gear .
5). When pressing during the working state, the induction cooker will
stop working immediately.
6). After pressing , the induction cooker will shut off automatically if
there is no any operation within 2 hours.
Ⅵ.How to Clean
1). Unplug and wait until the cooker is cooled down completely. Clean the
cooker after using each time.
2). If the pots/pans are used without being cleaned, discoloration or cooked on
stains may be caused.
3). Do not use benzine, thinner, scrubbing brush or polishing powder to clean
the induction cooker.
4). Wipe using dish washing agent and damp cloth.
5). Use vacuum cleaner to suck up dirt from the air intake and exhaust vent.
6). Never run water over the unit (Water gets inside may cause malfunction)
Warranty
Thanks so much for purchasing a VONCI product! It’s our on-going mission to
provide you with high quality commercial equipment and exceptional customer
service.
VONCI warrants this appliance to be free of defects in materials and
workmanship for a period of ONE year from the date of original purchase (the
Warranty Period). If the appliance exhibits such a defect, VONCI will, at its
option, refund or repair or replace it without cost for parts and labor.
For the fastest processing of a warranty claim, please e-mail and include the
product name, the order number, your complete contact information, and
detailed issue, including pictures when applicable.(Email Address:
[e-mail])
This warranty does not cover finishes (including staining, discoloration and
scratching), normal wear, nor does it cover damage resulting from accident,
misuse, dirt, water, tampering, improper use or care, service performed or
attempted by unauthorized service agencies, failure to provide reasonable and
necessary maintenance, or units that have been modified.
VONCI has the final interpretation for this warranty. Thanks.