Waring WPG Series User manual

Panini Grill CleaninG & MaintenanCe
The Waring™Commercial Panini/
Toasting Grill should be cleaned
after each use, with warm soapy
water.
The exterior of unit may be
cleaned by carefully wiping with
a damp cloth.
Clean plates while the unit is
warm, using warm soapy water
and the cleaning tool provided.
DO nOt USe COlD Water
On WarM Plate.
To clean drip tray, carefully
remove tray, wash with warm
soapy water and dry. Tray must
be completely dry before putting
back into the unit. Cleaning
Tool
Waring Commercial • 314 Ella T. Grasso Ave. • Torrington • Connecticut 06790 • Tel. [phone] • Fax [phone]
www.waringproducts.com • ©2009 Conair Corporation • 09wc15709

• Raise adjusting screw cover on back of unit
• Insert allen wrench into adjusting screw
• To increase handle tension turn allen wrench clockwise
• To reduce handle tension turn allen wrench counter clockwise
• Remove allen wrench from adjusting screw
• Lower adjusting screw cover
Panini Grill Handle Tension
Adjustment Instructions
Adjusting Screw
Cover
Start
PG-23144
Waring Commercial
P.O. Box 3201
314 Ella T. Grasso Ave.
Torrington, Connecticut 06790
1-800-269-6640
www.waringproducts.com
Finished
Adjusting Screw
Cover
Your Waring Commercial panini grill now comes with a handle tension control. This device allows you
to adjust the tension on the rear hinges so the top plate will remain open at the appropriate level and
maneuver to your satisfaction. The following is the proper way to adjust the tension control device.