Waterway 600-9101 User manual

2200 East Sturgis Road, Oxnard, CA 93030 • Ph. [phone] • Fax [phone]
www.waterwayplastics.com • [e-mail] 810-0187.1009
© 2009 Waterway Plastics
INSTALLATION & OPERATING INSTRUCTIONS
LO-PROFILE SPA DRAIN FILL VALVE (600-9101)
1. Find a place around the lower perimeter of the spa where the
drain can be installed. The hose on the back must be allowed to
travel several inches back and forth freely.
3. Slide the body of the spa drain through the hole and secure
with the nut. Silicone can be added to the threads to prevent the
nut from backing o.
4. The spa drain is designed to be used with ¾" spa ex hosing.
Cut the ex pipe long so that it can travel back and forth freely
with spa drain internal then glue it into the back of the spa drain
using the proper PVC sealant.
2. Mark where the drain is to be positioned and using a 2" hole
saw, drill a hole through the spa wall.

810-0187.1009
© 2009 Waterway Plastics
5. Pull knob out from the housing approximately 2" until it snaps
into place.
7. Thread hose onto the spa drain.
9. To disconnect the hose, push the hose inward approximately ½"
to shut the water ow o. Unthread the hose.
8. Pull the hose outward to allow water to ow. Push inward to
shut water ow o.
10. Thread the cap back on then push the internal back into the
housing until it snaps into place.
6. Remove cap by unthreading counter clockwise.