watt box WB-ACC-TRIGGER User manual

INSTALL GUIDE
WB-ACC-TRIGGER
The WattBox Trigger provides users with an easy way to cycle power on any or
all of the outlets on a WB-IP device.
Package Contents
• WattBox Trigger (normally open, momentary closed) switch with adhesive
backing
Installation
Position the switch in the desired location, then connect to the “REMOTE
TRIGGER” port on the WattBox using the phoenix connector included with the
IP device. Then log into the WB-IP interface to enable the trigger port and select
which outlets to power cycle.
Remote trigger
on the WattBox
Phoenix
connector
Extend wiring
up to 45'/13.7m
using Cat5 or other
conductors 24AWG
or larger. Wires can
be connected either
way (no polarity).

Warranty & Regulatory
Find details of this product’s 2-Year Limited Warranty at snapav.com/warranty,
or request a paper copy from Customer Service at [phone]. Find other
legal resources, such as regulatory notices and patent information, at
snapav.com/legal.
Technical Support
Phone: [phone]
Email: [e-mail]
Copyright ©2021, Wirepath Home Systems, LLC. All rights reserved. Control4 and SnapAV and their respective logos
are registered trademarks or trademarks of Wirepath Home Systems, LLC, dba “Control4” and/or dba “SnapAV” in the
United States and/or other countries. 4Store, 4Sight, Control4 My Home, Snap AV, Araknis Networks, BakPak, Binary,
Dragony, Episode, Luma, Mockupancy, Nearus, NEEO, Optiview, OvrC, Pakedge, Sense, Strong, Strong Evolve, Strong
Versabox, SunBriteDS, SunBriteTV, Triad, Truvision, Visualint, WattBox, Wirepath, and Wirepath ONE are also registered
trademarks or trademarks of Wirepath Home Systems, LLC. Other names and brands may be claimed as the property of
their respective owners. All specications subject to change without notice.
210224-1322