WaveMark Document 97-0009 Rev B
Notice of FCC Compliance
FCC ID UQY-SW1500
NOTE: This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference when the equipment is operated in a commercial environment. This equipment
generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with
the instruction manual, may cause harmful interference to radio communications. Operation of this
equipment in a residential area is likely to cause harmful interference in which case the user will be
required to correct the interference at his own expense.
Changes or modifications not expressly approved by WaveMark, Inc. could void the user’s authority to
operate the equipment.
Warning! FCC Radiation Exposure Statement:
This portable equipment with its antenna complies with the FCC’s RF radiation exposure limits set forth for
an uncontrolled environment. To maintain compliance follow the instructions below:
1) This transmitter must not be co-located or operating in conjunction with any other antenna or
transmitter.
2) Avoid direct contact to the antenna, or keep contact to a minimum while using this equipment.
FCC Compliance statement for Bluetooth® Radio:
This device contains FCC ID: PVH0946
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions;
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired
operation.
Bluetooth® QDID: B018179
Safety
This product must only be serviced by WaveMark trained service personnel.
Barcode LED Safety: EN 60825-1:1994+A1+A2 Class 1
[Add Lithium Ion battery safety notices]
Statement of Compliance
This device meets RoHS directive requirements.
