Wavetronix 0375 User manual

1 of 3WX-501-0375 • 03.22
6-conductor Cable 8-pin
Connector Pinout
The connector end of the SmartSensor 6-conductor cable mates to the 8-pin connector on the SmartSensor
Matrix and SmartSensor Advance. The sensor itself also contains internal wires that connect to the protective
earth lug.
If you need to terminate your own 6-conductor connector, the cable’s wires should correspond to the holes in the
the connector as shown in the diagram below.
A
+DC
Red
G
Common (ground)
Black
H
NC
B
Data bus +485
Orange/White
C
Data bus -485
Orange
F
Control +485
Blue/White
E
Control -485
Blue D
Drain/
shield
0375

2 of 3WX-501-0375 • 03.22
If you have a finished cable and want to use a meter to make sure that the wires are correct, the visible holes
correspond to the following wires:
E
Control -485
Blue
C
Data bus -485
Orange
B
Data bus +485
Orange/White
F
Control +485
Blue/White
A
+DC
Red
G
Common (ground)
Black
H
NC
D
Drain/
shield

3 of 3
© 2022 Wavetronix LLC. All rights reserved. Protected in the US by patents viewable at www.wavetronix.com/en/legal. Protected by Canadian Patent Nos. 2461411; 2434756; 2512689; and European Patent Nos. 1435036;
1438702; 1611458. Other US and international patents pending. Wavetronix, SmartSensor, Click, Command and all associated logos are trademarks of Wavetronix LLC. All other product or brand names as they appear are trade-
marks or registered trademarks of their respective holders. Product specifications are subject to change without notice. This material is provided for informational purposes only; Wavetronix assumes no liability related to its use.
WX-501-0375 • 03.22
The figure below shows the 6-conductor cable wire connections into a Click 222 surge protector.
+485A-485A +485B -485B
+485C -485C +485D -485D
DC+ DC- PE PE
+485A (orange stripe)
-485A (orange)
+485C (blue stripe)
-485C (blue)
DC+ (red)
DC- (black)
-485B (orange)
+485B (orange stripe)
-485D (blue)
+485D (blue stripe)
DC+ (red)
DC- (black)
Sensor 1 Sensor 2
Drain Drain
Earth ground