
3
Installation
The product must be installed and maintained by a
suitably qualiƂed person in compliance with the latest
applicable regulations and relevant legislation.
Claims based on defects attributable to improper
installation, application, operation and/or any modi-
Ƃcation carried out by the purchaser or third parties,
and the consequences thereof, are excluded.
Attention: The housing Acontaining the LED light
source is factory-sealed and does not need to be
opened during installation.
Installation Procedure
Installation – RAIL66 version
Prior to installing the luminaire, mount and connect
the selected RAIL66 mounting system in accordance
with relevant installation instructions
1) Switch off mains electrical supply.
2) Check that rating shown on luminaire label conforms
with mains electrical supply.
3) Determine desired position of luminaire Aon rail X,
dependent on aiming requirements and proximity
to a suitable mains outlet Y.
4) Attach clamp Bto rail X. Tighten wingnut C.
5) Remove protective cover Zfrom mains outlet Y.
Insert in-line connector Gand tighten.
Attention: On any mains outlet Y’ that is not used,
protective cover Z’ must remain Ƃrmly secured.
Check and ensure proper Ƃt and tightness.
6) Loosen screws Hand Islightly. Aim luminaire in
desired direction, retighten screws Hand I.
Installation – Space frame version
Suitable for space frame diameter 48-60 mm.
1) Switch off mains electrical supply.
2) Determine desired position of luminaire Aon space
frame X, dependent on aiming requirements.
3) Attach clamp Bto space frame X. Tighten
wingnut C.
4) Detach gear box cover Dby loosening screws S.
5) Check that rating shown on luminaire label conforms
with mains electrical supply.
6) Feed mains supply cable Ethrough cable gland G
(Fig. I).
7) Connect mains supply cable Eleads to respective
terminals in terminal connector K:
a) ON/OFF (L = Phase, N = Neutral, = Earthing)
b) 1-10 V/DALI (L = Phase, N = Neutral,
= Earthing, DA/DA = DALI control line,
D–/D+ = 1-10 V control line).
8) Reposition gear box cover Dand secure in position
by retighten screws S.
9) Loosen screws Hand Islightly. Aim luminaire in
desired direction, retighten screws Hand I.