Well TWILIGHT User manual

USER MANUAL
Model: TWILIGHT
(LED Clock radio with Lighting)
Thank you for choosing WELL. Please read carefully the following instructions and keep them within reach.
Reorder No: CLOCK-DESK-TWILIGHT-WL
OVERVIEW

1. “MEMORY TIME SET” button
2. “AL1/VOL-“ button
3. “AL2”VOL+” button
4. “HOUR/TUN-” button
5. “MIN/TUN+” button
6. “ ” button
7. “SNOOZE SLEEP / DIMMER” button
8. “LIGHT” button
9. STANDBY BATTERY COMPARTMENT
Use two ‘AAA’ size batteries to keep accurate time during temporary power interruption.
10. ANTENNA
Extend and reposition the antenna for best radio reception.
11. POWER CABLE
Plug cable into electrical outlet with correct voltage.
INDICATORS
A. Alarm 1 BUZZER
B. Alarm 1 RADIO
C. SLEEP
D. Alarm 2 BUZZER
E. Alarm 2 RADIO

FEATURES
Ambient light
Digital alarm clock with 9-minute snooze function
Integrated FM radio
Wake to radio or buzzer
Fall asleep to the radio
LED clock display
CLOCK and ALARM CLOCK OPERATION
Note: The time and alarm times cand only be set when the radio is turned off.
TIME SET
1. The digits will flash after connecting power to the radio, or press and hold down “MEMORY TIME SET”
button (1) for approximately 3 seconds until the display flashes.
2. Press “HOUR / TUN-” button (4) repeatedly to change the hour setting.
3. Press “MIN / TUN+” button (5) repeatedly to change the minute setting.
4. Press “MEMORY TIME SET” button (1) to confirm the time.
ALARM SET
This clock radio has dual alarms that can be set and used simultaneously and the procedures are the same.
Both alarms can either sound the buzzer or wake up to radio. Follow the instructions below to set alarm
time 1. For alarm time 2, substitute “AL1/VOL-” button (2) with “AL2/VOL+” button (3).
1. Press “AL1/VOL-” button (2) to view alarm time 1. The digits will flash.
2. Press “HOUR / TUN-” button (4) repeatedly to change the hour setting.
3. Press “MIN / TUN+” button (5) repeatedly to change the minute setting.
4. Press “AL1/VOL-” button (2) once to confirm and digits will stop flashing.
ACTIVATING THE ALARM
1. Once the alarm time is set, press “AL1/VOL-” button (2) once for alarm with buzzer (Indicator A will be
on) and twice for alarm with radio (Indicator B will be on).
2. Digits will stop flashing after a short while.
3. Press “AL1/VOL-” button (2) until all indicators off to turn off alarm.
4. When the alarm/radio sounds, press “ ” button (6) to turn alarm off or press “SNOOZE SLEEP /
DIMMER” button (7) for 9-minute snooze.
DISPLAY BRIGHTNESS
When the radio is off and the current time showing, press and hold “SNOOZE SLEEP / DIMMER” button (7)
to change the brightness of the display between high and low.

RADIO OPERATIONS
FM Radio Operations
To
Do this
Turn radio on or off
Press “ ” button (6)
Automatically scan
for the next station
Press and hold down “HOUR / TUN-” button (4) or “MIN /
TUN+” button (5)
Manually tune
Press “HOUR / TUN-” button (4) or “MIN / TUN+” button (5)
repeatedly
Change volume
(level 0-16)
Press “AL1/VOL-” button (2) or “AL2/VOL+” button (3)
Set preset station
Select radio frequency. Press and hold down “MEMORY TIME
SET” button (1). Press “HOUR / TUN-” button (4) or “MIN /
TUN+” button (5) to change preset station number. Press
“MEMORY TIME SET” button (1) to confirm.
Change preset
stations (1-20)
Press “MEMORY TIME SET” button (1) repeatedly.
Start sleep mode
With the radio on, press “SNOOZE SLEEP / DIMMER” button
(7) to enter sleep mode. Choose between 10 to 90 minutes.
(Indicator C will be on).
AMBIENT LAMP
Press “LIGHT” button (8) to turn lamp on and off.
NOTES
Please replace all batteries at the same time with only new batteries. Remove all batteries when the clock
radio is not in use for extended periods of time.
Place the clock radio only on protected furniture. Avoid direct sunlight and any area that may be exposed
to water or moisture.
DO NOT PLUG THE RADIO INTO AN ELECTRICAL OUTLET IF YOU ARE UNSURE OF THE VOLTAGE.
Waste electrical and electronic equipment are a special waste category,
collection, storage, transport, treatment and recycling are important because
they can avoid environmental pollution and are harmful to health. Submitting
waste electrical and electronic equipment to special collection centers makes
the waste to be recycled properly and protecting the environment. Do not
forget! Each electric appliance that arrives at the landfill, the field, pollutes the
environment!
Importer & distributor:
SC VITACOM ELECTRONICS SRL
CIF: RO 214527
Tel. [phone]*
[email protected]o, www.vitacom.ro