West Elm Angled Outline Floor Lamp User manual

US/CN Page 1of 2
Angled Outline Floor Lamp
Assembly Instructions
Important Safety Instructions:
•These instructions are provided for your safety. It is very important that they are read carefully and completely before
beginning the assembly and installation of this lighting fixture.
•This portable luminaire has a polarized plug (one blade is wider than the other) as a safety feature to reduce the risk of
electric shock. This plug will fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the
plug. If it still does not fit, contact a qualified electrician. Never use with an extension cord unless plug can be fully
inserted. Do not alter the plug. Do not attempt to defeat this safety feature.
•This fixture has been rated for up to one (1) 60-watt maximum TYPE A standard incandescent light bulb (not
included) or one (1) 13-watt compact fluorescent light bulb (not included) or one (1) 9-watt SBLED light bulb
(included). To avoid the risk of fire, do not exceed the recommended lamp wattage.
•Use with approved WEST ELM Shades only, having a minimum opening diameter of 3-1/2 inches and a minimum
lamp-to-shade spacing of 2-1/2 inches.
•This lamp is meant for indoor use.
•Save these instructions.
WARNING:
•To reduce the risk of fire, electrical shock or personal injury, always turn off and unplug the light fixture and
allow it to cool prior to replacing the light bulb.
•Do not touch bulb when fixture is turned on. Do not look directly at lit bulb.
•Keep flammable materials away from lit bulb.
Pre-assembly:
Remove all parts and hardware from box along with any plastic protective packaging.
Do not discard any contents until after assembly is complete to avoid accidentally discarding small parts or hardware.
Parts Included:
(A) Finial (1)
(B) Harp (1)
(C) Shade (1) (Packed Separately)
(D) Harp Caps (2)
(E) Socket (1)
(F) Saddle (1)
(G) Joints (2)
(H) Bottom Tubes (2)
(I) Harp Top (1)

US/CN Page 2of 2
To Assemble:
`
Care Instructions:
•Wipe clean with a soft, dry cloth or static duster.
•Always avoid the use of harsh chemicals or abrasive cleaners as they may cause damage to the fixture’s finishing.
Thank you for your purchase
Stores | catalog | www.westelm.com
USA 888-922-4119
1. Attach the Bottom Tube (H) into Joints (G) by turning
each Bottom Tube (H) clockwise until tight.
3. Unscrew the Finial (A) from the Harp Top (I).
2. Raise the Harp Caps (D) and insert the bottom ends of
Harp (B) into the Saddle (F). lower the Harp Caps (D)
until they cover the two-pronged Saddle (F).
4.1 Insert the specified light bulb into the Socket (E).
DO NOT EXCEED THE SPECIFIED WATTAGE.
4.2 Place the Shade (C) (Packed separately) over the
Harp (B), making sure the Harp Top (I) extends
through the hole at the top of the Shade (C).
4.3 Attach the Final (A) onto the Harp Top (I) and
tighten to secure the Shade (C) in place.