West Elm Droplet Table Lamp User manual

Page 1of 3
US/CN
Droplet Table Lamp
Assembly Instructions
Important Safety Instructions:
•This portable luminaire has a polarized plug (one blade is wider than the other) as a safety feature to reduce the risk
of electric shock. This plug will fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse
the plug. If it still does not fit, contact a qualified electrician. Never use with an extension cord unless plug can be fully
inserted. Do not alter the plug. Do not attempt to defeat this safety feature.
•These instructions are provided for your safety. It is very important that they are read carefully and completely before
beginning the assembly and installation of this lighting fixture.
•This fixture has been rated for up to two (2) 75-watt maximum TYPE A standard incandescent light bulbs (not
included) or two (2) 13-watt compact fluorescent light bulbs ( not included) or two (2) 9-watt LED light bulbs
(included). To avoid the risk of fire, DO NOT EXCEED THE RECOMMENDED LAMP WATTAGE.
•Use with approved West Elm Shades only, having a minimum opening diameter of 3-1/2 inches and a minimum
lamp-to-shade spacing of 2-7/8 inches.
•This lamp is meant for indoor use.
•Save these instructions.
WARNING:
•To reduce the risk of fire, electrical shock or personal injury, always turn off and unplug the light fixture and
allow it to cool prior to replacing the light bulb.
•Do not touch bulb when fixture is turned on. Do not look directly at lit bulb.
•Keep flammable materials away from lit bulb.
Pre-assembly:
Remove all parts and hardware from box along with any plastic protective packaging.
Do not discard any contents until after assembly is complete to avoid accidentally discarding small parts or
hardware.
Parts Included:
(A) Finial (1)
(B)Shade (1)
(C) Shade Holder Pipe (1)
(D)Cluster Body (1)
(E)Socket (2)
(F) Pull Chain (2)
(G) Lamp Base (1)

Page 2of 3
US/CN
To Assemble:
Screw the Shade Holder Pipe (C) into the Cluster Body (D)
Unscrew the Finial (A) from the Shade Holder Pipe (C)
1. Place the Shade (B) over the Shade Holder Pipe (C) making
sure the top of Shade Holder Pipe (C) extends through the top
ring of Shade (B).
2. Secure the Shade (B) by turning the Finial (A) onto the Shade
Holder Pipe (C).

Page 3of 3
US/CN
Care instructions:
•Wipe clean with a soft, dry cloth or static duster.
•Always avoid the use of harsh chemicals or abrasive cleaners as they may cause damage to the fixture’s finish
Thank you for your purchase
Stores | catalog | www.westelm.com
Insert the specified light bulbs into the Sockets (E). DO NOT
EXCEED THE SPECIFIED WATTAGE.