Westbo Carl User manual

1
Westbo Carl
WESTBO OF SWEDEN
Instruction Manual

2
• Do not install the electric replace directly on a carpet or other similar surface that may
hinder
the air circulation under it.
• After the electric fireplace is turned on and heated, the hot air outlet is at a high
temperature.Do
not place bedding, clothing, curtains, paper, etc. within 30 cm from the front of the
electric
replace and within 10 cm from the sides and back.
• When turning o󰀨 the electric replace and disconnecting the power, rst turn o󰀨 the
electric replace with the remote control, and then unplug the power cord.
• Do not place the electric replace in a humid environment, such as
a laundry room, bathroom, etc.
• When installing an electric replace, do not lay cables under carpets or ammables.
• When using an electric replace near a patient or child, pay attention to safety and take
extra care.
• You must use a well-grounded and fused socket.
• When the electric replace is in a heated state and objects are covered or covered at
the air inlet,
the heating components may be overheated. At this time,the product overheat protection
function will automatically cut off the input power.After 8 minutes cooling down it is
possible
to restart the unit
• When using the cooking plate, the diameter of the bottom of the pot should not exceed
13cm.
• The electric ceramic cooking plate on the top cannot automatically turn o󰀨 the power.
Please
do not leave it on without attention to avoid boiling water overowing and long-term dry
burning to cause potential hidden danger.
Safety precautions

3
Product overview
1. Technical data
• Namewestbo carl electric • Modelcarl electric
• Weight50kg • DimensionL40 cm ,W45 cm ,H95cm
• Rated VoltageAC 230+/-10V • Rated Power1850W
2.Product features
• The simulated wood burning is made of environmentally friendly resin materials, the
surface treatment of sheet metal parts is made of high temperature
resistant environmentally friendly plastic powder, and the materials used are
non-toxic and harmless,and meet the environmental standards.
• The ame is realistic, using coated glass three-dimensional imaging, with a real sense
of presence.
• The infrared remote control is used to control each function, and at the same time, the
auxiliary sound and light prompt function informs the user of the current working state.
• The stove body is made from cast iron
• Multifunctional combination, the perfect combination of electric
ceramic cooking plate and electric replace as these functions meet people's needs
for life.

4
Instructions
1. Ready to work
• Unpack the package, take out the top cover, electric ceramic stove,bottom feet
and accessories, and fasten the bottom feet to the bottom of the furnace body
with the combination screws allotted. See the gure below for the
installation method:
• Place the electric replace in a safe and suitable location and ensure a distance
of more than 30cm from combustible. Plug the power cord into the socket at
the bottom of the product to ensure that the power cord is not blocked or
crushed.
• Plug the power cord into a wall outlet rated min. 10A. When you hear a beep,
it indicates that the electric replace is powered on.
• The power input method is shown in the following gure.

5
2. Remote control function
Turn on / o󰀨
Five levels of brightness adjustment (5-4-3-2-1 cycle in turn).
Low heat / high heat (press low heat once, high heat 2 times,
turn o󰀨 heat 3 times).
Heating status display (press this key, the heating
statusindicator
lights up, and automatically turns o󰀨 after 3 seconds).
3.Heating functions.
• Low heat: Press the Heater button once, the internal buzzer of the product
sounds "beep", the on the ame screen lights up for 3 seconds and then goes out.
• High heat, press the Heater button twice, the product buzzer sounds three"beep",
the red light on the ame screen lights up for 3 seconds and then goes out.
• The location of the low heat and high heat indicator lights is shown in the
gure below:
Heating indicator Heating indicator
Low heat (blue light) High heat(red light)

6
1.The product cannot be turned on normally.
• Check whether the power input socket and the power plug are rmly connected
to make sure there is power on the socket.
• The electric replace is controlled by an infrared remote control. Please
check whether the remote-control battery is ok,Battery CR2025
2.The product cannot be turned on normally for heating.
• This electronic replace has an overheating protection system. If overheating
occurs, the system will turn o󰀨 the heater. If the heater stops working, please turn
o󰀨 the heater and check whether the air intake and exhaust are blocked.
• Unplug the heater, wait for the heater to cool completely, plug in the power to
reset the system, and then try to turn on the electric
4. Cooking plate function
•When using the cooking plate, the heat function on the stove will automatically
go down to “Low Heat” this to prevent the maximum power greater than 2300w
• The cooking plate has 5 levels of heating the maximum output is 1000w
Note:
Its forbidden to use any other cooking plate than the one provided by Westb.
Maintence and repair

7
Packing list
• Electric replace 1 PCS
• Electric ceramic heaters 1 PCS
• Remote control 1 PCS
• Instruction 1 PCS
• Power cable 1 PCS
Guarantee card
Westbo of Sweden
GUARANTEE CARD
The product conforms to the technical standards
Inspector:
Warranty
The warranty is valid in one year
after the purchase. Please provide
receipt with purchase date.

8
Outline dimensional

9

10
Westbo of Sweden AB
Industrigatan 8
S-333 75 Reftele, Sweden
Tel [phone]
[email protected]
www.westbo.net