Westbo Victoria Simple manual

MANUAL & INSTRUCTIONS
Westbo Victoria

2
Victoria General instructions
How to use
Air Controls
Westbo Victoria is equipped with one air control and it sits
under the stove, see picture on right.
Fire up
We recommend you to use fire starters or equivalent that
you find at your dealer.
By using them, you get a quick lit up of your wood and
cleaner combustion.
Never use lighter fluid. Place some thin wood together
with a couple of fire starters in the burning chamber open
the primary air control, it sits under the stove
Now lit up
Keep the door a little open, after a while when burning
well you can close the door
Continuous firing
Operate the fire with the air control
The conditions for controlling combustion vary depen-
ding on the temperature in the burning chamber and the
draught in the chimney. This you will understand more
after using the stove a couple of times.
A recommended amount of wood per hour is 1.5 to 3 kg.
Smell
At the first firing, a certain smell might occur. This depends
on the coating. The smell disappears after a few fires.
Emptying the ashes
The ashtray accessed by opening the door (D)
Open the grate by pulling the grate lever rake down the
ashes Empty the ash tray in a safe place. NOTE! The ash
can contain embers several days after the fire.
Cleaning glass
There are special glass cleaners available at your dealer. Do
not use abrasive cleaners.
Chimney fire
In case of chimney fire, all doors and air controls shall be
closed
If necessary contact the authorities.
ÖPPET
STÄNGT
D

3
Victoria Montage
Connection to an existing chimney.
Before you start it is important that you let the chimney sweeper
inspect your chimney.
This because you must be sure it is tight and properly dimensio-
ned for the stove.
Make your connection in the following order:
1. Measure out the centre of the hole
2. Use suitable tools to make the hole
3. We recommend that you use a flue spigot
4. Insert the flue pipe into the spigot then connect with the stove
seal between the spigot and flue pipe(preferably seal rope) The
pipe should not go into the actual
Chimney, cut if necessary. Apply additional sealant for other
joints.
5. Important! If your connection kit includes a rosette collar to
cover the hole in to the chimney put it on before connecting the
stove.
6. Contact chimney sweep for an inspection.
Preparation of the stove
Cut away the plastic strap that holds the carton in place over the
stove.
Lift the carton and check that the stove is not damaged. Lift the
stove in place.
Under the stove you find the crown.
Do not put on the Crown on until the stove have been installed.
Victoria has adjustable feet so you can adjust the stove to the
right level, if the floor is not flat.
Victoria is standard connected to the rear. If you like to connect
upwards you need to buy additional adapter that goes from the
rear to up. See picture
Adjustable feet
westbo of sweden

4
Victoria Replace the glass windows if broken
Replacing side glass
1. Start by taking out firebricks according to the instructions on
the next page.
2. Then remove grate bottom. The handle of the rust is assembled
with a nut that you access through the opening for the ash tray.
3. Remove the four screws that hold the side in place according
to the picture A and B.
4. Remove the clips that holds the glass in place (C).
5. Install the new glass and make sure that it seals tightly against
sealing rope. Replace if necessary.
6. Install the parts in reverse order.
A B
C
Replacing the front glass
Remove clips that hold the glass in place and then
install the new glass
Sealing string. Replace if necessary

5
Victoria Disassembe/assembe the firebricks
7 cm
A - Back-brick
B1 - Le big side-brick
B2 - Right big side-brick
C1 - Le small side-brick
C2 - Right small side-brick
D - Angle-brick
E - Roof-brick
F - Front-brick
1. Start with the small side-brick 2. Then remove the big side-brick by
first lift the roof brick that lock the
big-side brick
3. Take down the roof-brick 4. After that take out the angle-brick
Now it´s easy to remove the rest of
the bricks.
5. To assemble again just do it in
reverse order

6
A
A
522
495
450
450
310
1259 +- 10 mm
240
483
425
1134 +- 10 mm
876 +- 10 mm
*120
100
405
150 utv
Distance to combastible
Tecnical data
Weight: 170 kg
Material: Cast-iron
Output: 6 kW
Efficiency: 78,3 %
Distance to cobastable wall behind: 120 mm
CE tested: According to EN 13240
Brännbar vägg/med sidoglas
285
285
150/120
min 300
Brännbar vägg/med sidoglas
450/630
min 100
golvplåt
Victoria Technical info

7

Scandinavisk Spismiljö AB
Ekslingan 1, Väla Norra
254 67 Helsingborg
Tel [phone]
Fax [phone]
www.spismiljo.se