Westgate DAB-A16-50-100W-MCTP-SR Service manual

INSTALLATION INSTRUCTION MANUAL
LED COURTYARD LIGHT
MODELS:
DAB-A16-50-100W-MCTP-SR, DAB-B20-50-100W-MCTP-SR, DAB-B23-80-150W-MCTP-SR
Model number parameter list:
16 inches 20 inches 23 inches
1. Introduction
 This LED Flood light uses the latest in solid state lighting technology for long life, low maintenance,
and high efficiency.
Suitable for AC 120-347 VAC, 50 / 60 Hz .
Suitable for use in the following locations:
• Ambient Temp: -40~+40°C
• Wet Locations
Item Model Input Voltage Watt Input Current
（Max）Maximun Weight
ADAB-A16-50-100W-MCTP-SR 120-347VAC 50W/80W/100W 1.2A 26.9 lbs
BDAB-B20-50-100W-MCTP-SR 120-347VAC 50W/80W/100W 1.2A 28.6 lbs
CDAB-B23-80-150W-MCTP-SR 120-347VAC 80W/100W/150W 1.8A 30.9 lbs
WESTGATE MFG., INC | 2462 E 28th Street, Vernon, CA 90058 USA |1-323-826-9490|[email protected]

Note: Save these instructions for future reference.
2. Installation
For supply connections use wire rated for at least 90°C
Installation Steps:
Refer to the following diagram when you install the fixture.
1. Street Arm-single
Please connect and fix the corresponding parts with appropriate screws as shown.
Warning:
To avoid the risk of fire, explosion, or electric shock, this product should be installed, inspected, and
maintained by a qualified electrician only, in accordance with all applicable electrical codes.
•CAUTION:
THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION
CODE BY A PERSON FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT
AND THE HAZARDS INVOLVEDATTENTION-RISQUE
Warning:
To avoid electric shock:
•Be certain electrical power is OFF before and during installation and maintenance.
•Luminaire must be connected to a wiring system with an equipment-grounding conductor.
Warning:
To avoid explosion:
•Make sure the supply voltage is the same as the rated luminaire voltage.
•Do not install where the marked operating temperatures exceed the ignition temperature of the
hazardous atmosphere.
•Do not operate in ambient temperatures above those indicated on the luminaire nameplate.
•Keep lens tightly closed when in operation.
Fig. 1
Fig.2
Fig.3
The effect
The effect after the product
is installed
Connect and fix the fittings
with screws as shown
WESTGATE MFG., INC | 2462 E 28th Street, Vernon, CA 90058 USA |1-323-826-9490|Customerserv[email protected]

2. Street Arm-double
Please connect and fix the corresponding parts with appropriate screws as shown.
Fig.4
Fig.5
Fig.6
The effect after the product
is installed
Connect and fix the fittings
with screws as shown
WESTGATE MFG., INC | 2462 E 28th Street, Vernon, CA 90058 USA |1-323-826-9490|Customerserv[email protected]

3. Wall Mount Arm
Please connect and fix the corresponding parts with appropriate screws as shown,Caulk to mounting surface at all sides.
4. Mount Arm
Please connect and fix the corresponding parts with appropriate screws as shown,Caulk to mounting surface at all sides.
Fig.9
Fig.10
Fig.8
Fig.11
The effect after the product is
installed
The effect after the product
is installed
Connect and fix the fittings
with screws as shown
Connect and fix the fittings with
screws as shown
WESTGATE MFG., INC | 2462 E 28th Street, Vernon, CA 90058 USA |1-323-826-9490|Customerserv[email protected]

5.Surface Mount
Please connect and fix the corresponding parts with appropriate screws as shown,Caulk to mounting surface at all sides.
Double-end
Without sensor or photocell
Fig.12
Connect and fix the fittings
with screws as shown
Fig.13
The effect after the product
is installed
WESTGATE MFG., INC | 2462 E 28th Street, Vernon, CA 90058 USA |1-323-826-9490|Customerserv[email protected]

3. SENSOR /CCT/WATTAGE TUNABLE OPTION：
WARNING:
This fixture has a Photocell/Wattage/CCT controller. If a sensor is added to the sensor
socket, please set the photocell to OFF position and the Wattage Selector to the
maximum.
After installation, please
check whether the lighting fixture is firmly fixed.
check whether wires are connected correctly.
At last, turn on the power, and check if the lighting fixture works well. If not, please turn off the
power and contact with local dealer.
3K
4K
5K
80W
100W
150W
ON/OFF
Photocell
Motion sensor
CCT Tunable
( 3000/4000/5000K)
Wattage Tunable
VOL-
VOH-
VI-
V+
DM+
DM-
Supply Grounding(Green)
HOUSING
(Green)
G
Photocell , Power controller and CCT (Optional)
Neutral(White)
Line(Black)
LED DRIVER
Purple(+)DIM
Gray/Pink (-)DIM
Gray (-)
White (+)
LEDS
V0 (+)
HCCT
LCCT
Supply Line(Black)
Supply Neutral(White)
With Photocell/Watt/CCT controller
With sensor and Photocell/Watt/CCT controller
12V+ (Yellow)
12V+(Brown)
Neutral(White)
Line(Black)
LED DRIVER
Purple(+)DIM
Gray/Pink (-)DIM
Gray (-)
White (+)
LEDS
V0 (+)
HCCT
LCCT
Supply Line(Black)
Supply Neutral(White)
VOL-
VOH-
VI-
V+
DM+
DM-
Supply Grounding(Green)
HOUSING
(Green)
G
Photocell , Power controller and CCT (Optional)
Motion sensor
(Optional)
DM+(Black)
DM-(Gray)
WESTGATE MFG., INC | 2462 E 28th Street, Vernon, CA 90058 USA |1-323-826-9490|Customerserv[email protected]