Westward 4GU80A Instruction Manual

Westward High Lift
Vehicle Stands
Operating Instructions Manual 4GU80A
Please read and save these instructions. Read carefully before attempting to assemble, install, operate or maintain the product described. Protect yourself
and others by observing all safety information. Failure to comply with instructions could result in personal injury and/or property damage! Retain instructions
for future reference.
®
Description
Westward High Lift Vehicle Stands are designed to support rated capacity loads over
extended periods. Heavy gauge steel frame helps prevent distortion and twisting. These
high lift vehicle stands are designed to meet applicable ANSI/PALD Standards.
Note: Rated Capacity is Per Pair ONLY! Use ONLY one pair per vehicle.
General Safety Information
Study, understand,
and follow all
instructions before operating this device.
Rated capacity is per pair! Do not exceed
rated capacity. Use only on hard level
surface. Center load on saddle. Use as a
matched pair to support one end of a
vehicle only. Use only one pair per vehicle.
Stands are not to be used to
simultaneously support both ends or one
side of a vehicle. No alterations shall be
made to this product. Failure to heed
these markings may result in personal
injury and/or property damage.
Before Use
1. Before using this product, read the
operator’s manual completely and
familiarize yourself thoroughly with the
product and hazards associated with
its improper use.
2. Use high lift vehicle stands in pairs on
hard level surface capable of
sustaining rated capacity loads. Use
one pair per vehicle.
3. Insert roll pin into the bottom hole of
the extension tube.
4. Load and stands must be stable before
working on, around, or under load.
5. Inspect before use. Do not use if bent,
broken, cracked, or otherwise damaged
components are noted.
6. Consult vehicle manufacturers service
manual for proper lifting and support
locations.
Operation
TO SUPPORT
1. Adjust height by pulling up extension
tube. Ensure stopper is positively
engaged into extension tube. Place
stands under support points.
2. Lower the load slowly onto the stands.
Do not remove lifting device.
IMPORTANT: Stopper must be securely
inserted.
TO REMOVE
1. With suitable lifting device, raise
vehicle clear of stands.
2. Release stopper and allow extension
tube to glide down to lowest position.
3. Carefully remove stands, then slowly
lower vehicle with lifting device.
Maintenance and Storage
Periodically inspect product. Ensure all
parts move freely. Do not apply oil or
grease to this product. Wipe clean before
use. Maintain labels and replace as
needed, contact your local Grainger.
Store stands in upright position and in a
clean, dry area. Place stopper in stopper
holder on base section.
NOTE: Other than Label and Manual, No
replacement parts available for these
units. Replace as a matched pair only.
Specifications
Min. Max.
Model Capacity Base Size Height Height
4GU80A 10 Ton 16” x 16” 28-1/4" 47"
Roll Pin
Stopper
Saddle
Base Section
Height Adjustment
Holes
Figure 1- High Lift Vehicle Stand Components
Collar
SHI 032
Printed in China
02/10
Stopper Holder
Lanyard
Extension tube

Westward Operating Instructions Manual 4GU80A
Manufactured for Grainger International, Inc. Lake
Forest, IL 60045 U.S.A.
Westward High Lift Vehicle Stands
®
LIMITED WARRANTY
WESTWARD ONE-YEAR LIMITED WARRANTY.High Lift Vehicle Stands , covered in this manual, are
warranted by Westward to the original user against defects in workmanship or materials under normal use for
one year after date of purchase. For limited warranty claim procedures, see PROMPT DISPOSITION below.
This limited warranty gives purchasers specific legal rights which vary from jurisdiction to jurisdiction.
LIMITATION OF LIABILITY.To the extent allowable under applicable law, Westward's liability for consequential
and incidental damages is expressly disclaimed. Westward's liability in all events is limited to and shall not
exceed the purchase price paid.
WARRANTY DISCLAIMER. Westward has made a diligent effort to provide product information and illustrate
the products in this literature accurately; however, such information and illustrations are for the sole purpose of
identification, and do not express or imply a warranty that the products are MERCHANTABLE, or FIT FOR A
PARTICULAR PURPOSE, or that the products will necessarily conform to the illustrations or descriptions.
Except as provided below, no warranty or affirmation of fact, expressed or implied, other than as stated in the
"LIMITED WARRANTY" above is made or authorized by Westward.
PRODUCT SUITABILITY. Many jurisdictions have codes and regulations governing sales, construction,
installation, and/or use of products for certain purposes, which may vary from those in neighboring areas. While
Westward attempts to assure that its products comply with such codes, it cannot guarantee compliance, and
cannot be responsible for how the product is installed or used. Before purchase and use of a product, review the
product applications, and all applicable national and local codes and regulations, and be sure that the product,
installation, and use will comply with them.
Certain aspects of disclaimers are not applicable to consumer products; e.g., (a) some jurisdictions do not allow
the exclusion or limitation of incidental or consequential damages, so the above limitation or exclusion may not
apply to you; (b) also, some jurisdictions do not allow a limitation on how long an implied warranty lasts,
consequentially the above limitation may not apply to you; and (c) by law, during the period of this limited
warranty, any implied warranties of implied merchantability or fitness for a particular purpose applicable to
consumer products purchased by consumers, may not be excluded or otherwise disclaimed.
PROMPT DISPOSITION. Westward will make a good faith effort for prompt correction or other adjustment with
respect to any product which proves to be defective within limited warranty. For any product believed to be
defective within limited warranty, first write or call dealer from whom the product was purchased. Dealer will give
additional directions. If unable to resolve satisfactorily, write to Westward at address below, giving dealer's
name, address, date, and number of dealer's invoice, and describing the nature of the defect. Title and risk of
loss pass to buyer on delivery to common carrier. If product was damaged in transit to you, file claim with carrier.
Manufactured for Grainger International, 100 Grainger Pkwy., Lake Forest, Illinois 60045 U.S.A.