Whirlpool ADG 211 User manual

www.sacoapartments.com
Operating Instructions – Dishwasher Whirlpool ADG211
Control Panel
Wash cycles
Washing detergent
Open the detergent dispenser using button D. Insert the dishwasher
tablet into compartment A and close the cover C. The detergent
dispenser opens at the right time according to the wash cycle.
Starting the dishwasher
1. Open the door and press the ON/OFF button.
2.
Measure out the detergent.
3.
Load the racks
4.
Select the wash cycle, using the above table as a guide, by pressing the P button.
5.
Start the wash cycle by shutting the door.

www.sacoapartments.com
6. The end of the wash cycle is indicated by beeps and by the flashing of the indicator light of the selected wash
cycle. Open the door, switch off the appliance by pressing the ON/OFF button.
7.
Wait a few minutes before removing the crockery in order to avoid burns.
Changing a wash cycle in progress
To change the wash cycle open the door, taking care to avoid the escaping steam, and press and hold for
ON/OFF button, the machine will switch off. Switch the machine back on using the ON/OFF button and select the
new wash cycle and any options desired, start the cycle by closing the door.
Adding extra crockery
Without switching off the machine, open the door, taking care to avoid the escaping steam, and place the
crockery inside the dishwasher. Close the door, the cycle starts from the point at which it was interrupted.
Accidental interruptions
If the door is opened during the wash cycle or there is a power cut, the cycle stops. It starts again from the point
at which it was interrupted once the door has been shut or the electricity supply restored.