Whirlpool ADP 6600 SL User manual

You can read the recommendations in the user guide, the technical guide or the installation guide for WHIRLPOOL ADP 6600 SL.
You'll find the answers to all your questions on the WHIRLPOOL ADP 6600 SL in the user manual (information, specifications,
safety advice, size, accessories, etc.). Detailed instructions for use are in the User's Guide.
User manual WHIRLPOOL ADP 6600 SL
User guide WHIRLPOOL ADP 6600 SL
Operating instructions WHIRLPOOL ADP 6600 SL
Instructions for use WHIRLPOOL ADP 6600 SL
Instruction manual WHIRLPOOL ADP 6600 SL
Your user manual
WHIRLPOOL ADP 6600 SL

Manual abstract:
g. oil used for frying) or candle wax. If a fault occurs or you wish to change the current programme, press the âSTARTâ button for about 5 seconds
until the Start indicator lamp switches off! If regeneration salt is to be added, immediately start a wash programme in order to eliminate any residual salt
(rinsing alone is not sufficient). Sometimes even though the regeneration salt container has been filled, the corresponding indicator lamp (if fitted) will light
up during the first wash cycle after filling with salt. â¢ â¢ â¢ â¢ If a fault occurs, before contacting our After-Sales Service, make the following checks
to try and remedy the problem: The dishwasher is not working: â¢ Is the plug properly inserted in the wall socket? â¢ Is there a power failure? â¢ Is the
dishwasher switched on? â¢ Has the Start button been pressed? â¢ Has the delayed start timer been set (if fitted)? â¢ Is the water supply tap on? â¢ Is
the flow of water obstructed by impurities? If so, close the water supply tap, detach the water hose and clean the filter. Then re-connect the water hose to the
tap and open the water tap once again. â¢ Are the filters clogged? (See âCare and maintenanceâ chapter in the user instructions). â¢ Is the door
closed properly? â¢ Is a fault indicated? (The Start indicator lamp flashes). Start the programme again from the beginning: press the Start button for about
5 seconds, until the Start indicator lamp switches off. Select a new programme and press the Start button.
â¢ Your full address and telephone number. Please read the user instructions carefully. Dishwasher loading instructions UPPER RACK LOWER RACK
Half Load / Multizone Depending on the model, rack features may vary (see âUpper and lower rackâ description)..
Your user manual
WHIRLPOOL ADP 6600 SL
Powered by TCPDF (www.tcpdf.org)