Cycle and Option ©esc iptions
Sensor Heavy Normal 1-Hour Soak&
Wash Clean
°,,,• ...... • •,• ...... ,°,
i Cycles Delay
°°° •• ...... ° •......... ,* [Start
[_ hold 3sec Resume
O•°••,,,•••,,,•• ....... .°°°°.°°•• ................ °° °°o,°°°•°°
Sani Heat HiTemp Target •CanceVDr_n
Rinse Dry Wash Clean .. :ho_dssec
%°,,,•••°,°••, ....... °°.°°° .... • ................ ° °.•°•°.
•,,°••°,,°••o
This information covers several different models. Your dishwasher may not have all of the cycles and options described. Estimated cycle
times may increase or decrease depending on water temperature, soil conditions, dish load size, and options selected. You can customize
your cycle by selecting an option.
See option selections. If you change your mind, press the option again to turn off the option, or select a different option. You can change
an option anytime before the selected option begins. At each stage of the wash cycle, you may hear noises that you are not used to
hearing in your previous dishwasher. Each cycle will provide a series of pauses and water sprays throughout the wash cycle. This is
normal and will provide optimal cleaning performance.
CYCLES ESTIMATED WATER USAGE
WASH TIME GALLONS
(HH:MM) (LITERS)
The most advanced and versatile cycle, This cycle senses load size, so!! amount, and .......... 2:30 ............ &38to 7:4
sensor toughness of soil, to adjust the cycle for optimal cleaning using only the amount of (12.8 to 28.0))
water and energy needed. Use for a!! s0i! level&
Heavy
Use for hard-to-clean, heavily soiled pots, pans, casseroles, and tableware. 3:28 7.4
(28.1)
This cyc!e with on!y the Heated Dry option se!ected, and without other options se!ected, 2:32 2.4 to 7:4
Norma! is recommended to comp!ete!y wash and dry a full load of normally soiled dishes. The (9.09 to 28)
energy usage label is based on this cycle and option combination.
l-Hour
Wash
For fast results, 1-Hour Wash will clean dishes using slightly more water and energy.
Select the Heat Dry option to provide best dry performance. 1:00 7.87 (29.8)
This cycle quietly soaks dishes with an extended prewash which eliminates the need to 7:31 7.4 (28,0)
SoN k &
Clean presoak dishes saving personal time and efforL For optimal cleaning results during the
==. Soak & Clean cycle add prewash detergent: Use this cyc!e for loads with heavy amounts
of dried on or hard to clean baked,on food.
IMPORTANT: The sensor in your dishwasher monitors the soil level. Cycle time and/or water usage can vary as the sensor adjusts the
cycle for the best wash performance. If the incoming water is less than the recommended temperature or food soils are heavy, the cycle
will automatically compensate by adding time, heat and water as needed.
OPTIONS CAN BE ADDED
SELECTED ADDED TIME WATER
WITH WHAT IT DOES TO CYCLE GALLONS
(LITERS)
Activates the TargetC!ean TM sPray jets and provides Sensor Raises main 0:12 to 0:57 0 to 4.8
intensified water spray to the back of the lower level Heavy wash temperature (Oto 182)
Tarqet rack. Normal from 105OF ........................................ ".......
Cle-an May add heat and time to the cyclel Soak & Clean (41°C) to120°F
Raises main wash temperature to improve cleaning Sensor Raises the main
"' for loads containing tough, baked-on food. Heavy washtemperature
HiTemp Normal to 135°F (57°C)
Wash Soak & Clean
0:05 to 0:13 0 to 3.86
(0 to 14.6)
Sanitizes dishes and glassware in accordance with Sensor Raises the main 0:05 to 1:06 0 to 3.86
@ho,_s_ NSF International NSF/ANSI Standard 184 for Heavy wash temperature (0 to 14,6)
• Sani- Residential Dishwasher& certified residential Normal to t35°F i57°C)
d shwashers are not ntended for censed food and the f nar nse
Rrise establishment& The San! ndicator indicates at the temperature to
end of the cyc e whether the San! Rinse option was t56°F (69°C)
successfully comp!eted. If indicator does not
activate, it is probably due to cycle being interrupted.
