Whirlpool LE6800XS User manual

AUTOMATIC
DRYERS
Electric Model
LE6800XS
and
Gas Model
LG6801XS
Microwave Ovens, Trash Compactors, Room Au Condltloners. Dehomldrfrers. Automatic Washers, Clolhes Dryers, Freezers. Refrlgeralor-

Parts and features
CYCLE CONTROL KNOB
LAUNDRY INFORMATION CENTER
TEMPERATURESELECTOR
START BUllON
LINT SCREEN
DRYER DRUM
MODEL
AND SERIAL
NUMBER PLATE
DOOR
Remove the Con-
sumer Buy Guide label
before using your
dryer. It will be easier
to remove.
Wipe out the dryer
drum with a damp
cloth to remove dust
from storing or ship-
ping.
Copryour Model and Serial Numbers here
When you need service or call with a
question, have this information ready:
1. Complete Model and Serial Numbers
(from the plate located as shown). Mode, Number
2. Purchase date from sales slip.
Copy this information in these spaces. Seria’ Number
Keep this book in the Laundry Information
Center with your “Dryer Guide:’ sales slip PurchaseUate
and warranty
Please complete and mail the Owner
Reglstratlon Card furnished with this ~~$B,~$~,$~r
product.
Page
2
3
4
Contents
PARTS AND FEATURES
IMPORTANT SAFETY
INSTRUCTIONS . .
OPERATING INSTRUCTIONS.
Selecting a Cycle and
Starting Your Dryer
Automatic Cycles .
limed Drying
DRYING TIPS
FLUFFAIR Setting .
TUMBLEPRESS@Setting
Automatic DRY-MISER@)
Control .
Gentle Heat. . . . 7
7
Drying Times
Mixed Loads .
End-of-Cycle Signal . .
Lint Signal . . . .
LINT SCREEN .
LINT REMOVAL. . . . .
CARING FOR YOUR DRYER..
Cleaning Dryer Interior.
Vacation Care . . . .
IF YOU NEED SERVICE OR
ASSISTANCE . . . . .
WHIRLPOOL DRYER
WARRANTY .
Page
8
B
B
B
9
9
10
10
10
. 11
12
2 01987 Whirlpool Corporation

Addifional Safety lnsf~~cfions and Your ResponsibMfies
ALWAYS shut off the gas valve before
leaving on vacation.
NEVER use or store flammable fluids
(dry-cleaning solvents, gasoline, ker-
osene) in or near your dryer. These sub-
stances give off vapors that can create
a FIRE HAZARD or EXPLOSION.
NEVER operate the dryer if...
l it is not working right [i.e. noisy, too hot).
l it is damaaed.
ALWAYS unplug the power supply cord
or turn off electrical power before at-
tempting to service the dryer. Shut off
GAS VALVE if yours is a gas dryer.
You are personally responsible for
maklng sure that your dryer...
l is properly maintained.
l is properly installed and leveled in a
well ventilated room’ on a floor that
can support the weight.
l parts are missing (i.e. door latch). . is located in an area where the tem-
l all panels are not in place. perature is above 45°F (7.2%).
l the lint screen is loose, damaged or
l is connected to the proper outlet and
missing. electrical supply.’
l is properly connected to fuel and ex-
l FOR YOUR SAFETY l
haust systems.*
IF YOU SMELL GAS:
l is not installed against drapes or
1. OPEN WINDOWS. curtains.*
2. DON’T TOUCH ELECTRICAL SWITCHES.
l is used only for jobs normally ex-
3. EXTINGUISH ANY OPEN FLAME. petted of home clothes dryers.
4. IMMEDIATELY CALL YOUR GAS
l is not used by children or anyone un-
SUPPLIER. able to operate it properly.
*See “lnstallatlon Inrtructlons” for
complete Informatlon.
3

I
I I’
SUGGESTED SUGGESTED
TYPEOF LOAD CYCLE TEMPERATURE
COTTONS - LINENS
EXTRAHEAVY-Bedspreads, HEAVY
mattress pads, quilts . . . . . . , . . . . . HIGH
HEAVYWEIGHTFABRICS- Towels,
jeans, corduroys, work clothes . . . .
MEDIUMWEIGHTCOTTONS- AUTOMATIC
Sheets, plllowcases, cotton REGULAR PERM’I PRESS
underwear,dlapers . . . . . . . . . . . MED
LIGHTWEIGHTCOTTONS- Batistes, KNITSGENTLE
organdies, lingerie . . . . . . . . . . . . . . . . . LOW
PERMANENTPRESS,SYNTHElICS
ANDBLENDS -
HEAVYWEIGHTFABRICS-Work clothes.
jackets, ralncoats . . . . . . . , . . . . . .: . . . .
MEDIUMWEIGHTFABRICS-Shirk, play
clothes,sheets, slacks. . . . . . . . . . . . .
LIGHTWElGHTFABRICS- Lingerie,
blouses,dresses.......................
AUTOMATIC PERMITPRESS
PERMANENT MED
PRESS MED LOW
KNITS
HEAWWElGHT- Cottons, rayons,
blend&T-shirts, slacks, shirts . . . . . . . .
LIGHTWEIGHT- Synthetics (polyester,
acrylic, etc.] and blends, lingerie,
blouses, dresses . . . . . . . . . . . . . . . . . .
LIGHTWEIGHT AND DELICATE FABRICS
Sheer Curtains (2 or 3 panels) . . . . . . . .
Gauze, lace, etc. . . . . . . . . . . . . . . .
AUTOMATIC MED LOW
PERMANENT
PRESS KNITSGENTLE
LOW
AUTOMATIC
PERMANENT Ex LOW
PRESS
RUBBER,PLASTIC, HEAT-SENSITIVE
FABRICS
FOAM RUBBER- Pillows, bras,
stulted toys . . . . . . . . . . . . . . . . . . . . . .
PLASTIC- Shower curtains,
tablecloths. . , . . . . . . . . . . . . . . . . . . . .
RUBBER-BACKEDRUGS. . . .
FLUFF
AIR Ex LOW

1
. Select a CYCLE
Turn the Control Knob either way to
point to the cycle and setting you
want. See page 6 for information on
the cycles.
3
n Push the STARTButton
The dryer will start tumbling when you
push the STARTButton.
Ifthe STARTButton is pushed when the
Cycle Control Knob is pointing to an
OFFarea, the End-of-Cycle Signal will
sound. Dryer will not start.
2
Set
n TEMPERATURESELECTOR
The Temperature Selector can be set
on any desired temperature or any-
where between 2 temperatures.
To stop and restart
the dryer
TOStop the dryer, open the door (or
turn the Control Knob to OFF).
to r&tart the dryer, close the door,
select Cycle, if necessary, and push
START.
The Cycle Control Knob should point to an OFF area when the dryer is
not In use. If the dryer Is stopped before the cycle Is finlshed, turn the Cycle
Control Knob to an OFF area. 5

The automatic cycles
The automatic cycles allow you to se-
lect the degree of dryness you prefer
for the clothes being dried.
The Control Knob will not move until
the clothes load is almost dry, or the
COOL-DOWN portion of the cycle has
been reached. After COOL-DOWN, the
knob automatically moves to an OFF
area and tumbling stops.
weight cotton items. The load tumbles
wlthout heat during the last 5 mln-
utes. This helps make the load easier
to handle.
press, knits and other synthetic fab-
rics. The load tumbles without heat
during the last 10 minutes. This helps
keep wrinkles from setting in, and
makes the load easier to handle.
Forthe first few loads, set the Control
Knob to point to an * in either auto-
matic cycle. When the dryer stops, feel
the dried items.
l If items are drier than you like, use
a setting to the right of the * the next
time vou drv a similar load.
l If items are not as dry as you like, use
a setting to the left of the * the next
time you dry a similar load.
Timed drying
Usethe TIMEDDRYING Cycle for
any load you want to dry by time. For
example: small loads, large bulky
items, items to be fluffed or dusted
with the FLUFFAIR heat setting.
l Turn the Control Knob to the number
of minutes you want-from 10to 70.
l The last 5 minutes of this cycle are
without heat-a cool-down time.
This helps make the load easier to
6 handle.

Drying tips
TUMBLE PRESS” Settine
The d rdoes not heat when the
Temperature Selector is set on FLUFF
AIR.This setting can be used to fluff
bedding, plastic tablecloths, foam
rubber pillows, stuffed toys, sneakers,
etc.
1. Turn the Control Knob to the number
of minutes you want in FLUFFAIR.
2. Push the STARTButton.
The TUkBLEPREii setting removes
wrinkles from dry clothing such as
items that may have been packed
in a suitcase, closet, or items not
removed from the dryer.
1. Set Control Knob to TUMBLEPRESS.
2. Set Temperature Selector to PERMIT
PRESS/MED.
3. Push STARTButton.
The load will tumble in heated air
for 15minutes. The heat shuts off and
the dryer continues to tumble the load
for 5 more minutes.
For best results, TUMBLEPRESSonly a
few items at a time. Putthem on hang-
ers or fold them as soon as the dryer
stops.
Automatic DRY-MISER”
Control
The thermostat senses the air
temperature. The dryer automatically
shuts off when the selected dryness
is reached.
Gentle Heat
The dryer automatically reduces
the heat settings in HEAVYHJGHand
PERMITPRESSMED cycles. During
the last few minutes of each of
these cycles the dryer temperature
gradually reduces to a lower heat
setting. This helps prevent
overdrying.

Drying times Mixed loads
Drying times will vary depending on: When drying a load with different
l amount of moisture in the clothes. kinds and weights of fabrics, use the
. . * .. .. . . . _
l type and weight of the fabric.
l size of the load. cycle suggesrea ror me llgnresr rao-
rics. When the dryer stops, remove dry
items and reset the control.
l room temperature around the dryer.
l temperature of the wash rinse water.
l amount of lint in the lint screen.
l dryer temperature selection.
See in your “Dryer Guide” for
more information.
End-of-cycle signal The dryer sounds a signal to let you know when
the cycle isfinished. The signal cannot be turned
off and is not adjustable.
The signal is helpful when you are drying per-
manent press, synthetics and other items that
should be taken oui as soon as the dryer stops.
&’ f.., signal
UJ
0
0
Clean lint screen before each load. If you
neglect to clean your lint screen, the signal will
sound. The (whistle tone] signal lets you know
the air flow is being restricted. Restricted air flow
reduces drying efficiency,
Turn off the dryer and clean the lint screen as
shown on page 9.

I
I
I
I
Lint screen
Clean the lint screen before each load. A screen blocked by lint can
increase drying time and may be a FIREHA
Open the lid and pull the lint screen
straight out.
ROLL the lint off the screen with
your fingers.
DO NOT rinse or wash the screen.
Push the screen firmlv back into olace.
Lint removal
Lint can gather inside the dryer and create a FIRE HAZARD. This lint should
be removed at least every 2 to 3 years, or more offen,
deDendlna on drver usage.
ELECTRIC DRYERS GAS DRYERS
Cleaning should be done only by a qualified person.
WARNING:
l Avold electrical shock
hazard - unplug power
supply cord or turn off
electrical power.
l Avold Injury or damage - do not
put hands Inside cabinet.
l Make sure dryer is cool.
1. Remove back panel (electric)
or lower access panel (gas].
2. Avoid damaging wires,
thermostats, funnel or igniter.
3. Remove lint from shaded area -
see art-with a soft brush or
vacuum cleaner.
4. Replace panel; reconnect and
re-level dryer. 9

Remove i&se and sharp objects
from pockets and cuffs before drying -
pins, buckles, etc. Close metal
zippers.
Wipe off ail spills with a damp, soft
cloth. Spills allowed to remain may
dull or damage the finish.
Never leave wet or damp laundry
in your dryer.
Sharp or heavy objects should
never be put on or in the dryer.
Check pockets for bolts, nuts etc.
10
Some pretreatment products can
damage dials, consoles and finish.
Do not use these products on or near
your dryer.
Cleaning dry&=interior
0
WARNING: Before
cleaning interior, unplug
power supply cord or,
turn off electrical power to
avoid electrical shock hazard.
Garments which contain unstable
dyes, such as denim blue jeans or
brightly colored cotton items, may
discolor the dryer interior. Ifthe
interior is discolored, clean with
one of the following methods to
avoid staining later load items.
Powdered laundry detergent and
very warm water
Make a paste with detergent and
very warm water. Apply paste to
a soff cloth and scrub area until
all excess dye is removed. Wipe
thoroughly with a damp cloth.
Tumble a load of rags. -OR-
liquid spray household cleaner
Spray on stained area. Rub with
a cloth until all excess dye is
removed. Tumble a load of rags.
Vacation care
l Unplug power cord or turn off
electrical power.
l For gas dryers, close gas valve.
0 Clean lint screen.