Whirlpool MT4155SPB3 User manual

MICROWAVE OVEN BUILT.INTRIM KIT
INSTALLATIONINSTRUCTIONS
MICROWAVE OVEN SAFETY
Your safety and the safety of others are very important.
We have provided many important safety messages in this manual and on your appliance. Always read and obey all
safety messages.
This is the safety alert symbol.
This symbol alerts you to potential hazards that can kill or hurt you and others.
All safety messages will follow the safety alert symbol and either the word "DANGER" or
"WARNING." These words mean:
You can be killed or seriously injured if you don't
immediately follow instructions.
You can be killed or seriously injured if you don't
follow instructions.
All safety messages will tell you what the potential hazard is, tell you how to reduce the chance of injury, and tell you
what can happen if the instructions are not followed.
INSTAILATIONINSTRUCTIONS
Check that you haveeverything necessaryfor correct installation.
• Gloves • Scissors
• Safety glasses • Flat-blade screwdriver
• Measuring tape • Stud finder (optional)
•Pencil
•Upper trim piece (1)
•Lower trim piece(l)
•4 mm x 16 mm tapping screws (4)
• 4 mm x 8 mm tapping screws (7)
Check local codes. Check existing electrical supply. See
"Electrical Requirements."
All electrical connections should be made by a licensed, qualified
electrical installer.
IMPORTANT: Save Installation Instructions for local electrical inspector's use.
8204843/3828W5U0303

NOTE: Do not locate microwave oven within 2 ft (61 cm) of any
gas or electric range, cooktop or oven.
Check the location where the microwave oven will be installed.
The location must provide the following:
• 20% in. x 141&in. x 16 in. (51.8 cm x 36.9 cm x 40.7 cm) wood
cabinet or shelf with a solid plywood bottom
• Support for weight of 100 Ibs. (45.4 kg).
• 203/8in. (51.8 cm) wide minimum opening
• 16 in. (40.7 cm) minimum depth
• Temperature above 50°F (10°C) for proper operation
• Grounded electrical outlet (see "Electrical Requirements"
section) on rear wall of cabinet enclosure
NOTE: There must be at least one wall stud within cabinet
opening.
\\\
,I
Min 20 _/8" (51.8 cm)
1. Location of grounded outlet
2. Opening in cabinet
(3cm)
Min,
141/2"
(35,9 cm)
[ 1'_
(2.5 cm)
J
ElectricaJ Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in
death, fire, or emectricaI shock.
Observe all governing codes and ordinances. A 120-Volt, 60-Hz,
AC-only, 15- or 20-amp fused electrical supply is required.(A
time-delay fuse is recommended.) It is recommended that a
separate circuit serving only this appliance be provided.
GROUNDING _NSTRUCT_ONS
For all cord connected appliances:
The microwave oven must be grounded. In the event
of an electrical short circuit, grounding reduces the
risk of electric shock by providing an escape wire for
the electric current. The microwave oven is equipped
with a cord having a grounding wire with a grounding
plug. The plug must be plugged into an outlet that is
properly installed and grounded.
WARNING: Improper use of the grounding plug can
result in a risk of electric shock. Consult a qualified
electrician or serviceman if the grounding instructions
are not completely understood, or if doubt exists as to
whether the microwave oven is properly grounded.
Do not use an extension cord. If the power supply cord
is too short, have a qualified electrician or serviceman
install an outlet near the microwave oven.
mFor a permanently connected appliance:
This appliance must be connected to a grounded,
metallic, permanent wiring system, or an equipment
grounding conductor should be run with the circuit
conductors and connected to the equipment
grounding terminal or lead on the appliance.
SAVE THESE iNSTRUCTiONS

1,
2.
3.
Empty the microwave oven of any packing materials.
Clean the inside with a soft, damp cloth.
Check for damage, such as:
• a door that is not lined up correctly
• damage around the door, or
• dents on the interior or exterior of the oven.
If there is any damage, do not operate the oven until a
designated service technician has checked it and made any
needed repairs.
_ ¢>.:: ;_
Install the upper trim piece using 3-8 mm tapping screws
(provided).
1
I
3. Remove 2 screws from the front of the base plate. Mount the
lower trim on the base plate using 2-8 mm screws.
1
1.Lower trim piece attached to base plate
Install microwave oven in cabinet enclosure.
!. Upper trim piece
2. Attach the duct with 2-8 mm screws.
I
i i
L.I{
5,
6.
Attach the upper trim piece to the cabinet with 2-16 mm
screws.
Attach the lower trim piece to the cabinet with 2-16 mm
screws.
J
Plug in microwave oven.
1. Duct

8204843/3828W5U0303
© 2003 Whirlpool Corporation
Atl rights reserved ® Registered Trademark/TM Trademark of Whirlpool, US.A. 7/03
Printed in China