Whirlpool AKG65901IX User manual

11
INSTRUCTIONS FOR USE
INSTALLATION
ELECTRICAL CONNECTION
BEFORE USING THE OVEN
SAFEGUARDING THE ENVIRONMENT
PRECAUTIONS AND GENERAL RECOMMENDATIONS
OVEN ACCESSORIES
COOKING TABLE
CARE AND CLEANING
TROUBLESHOOTING GUIDE
AFTER SALES SERVICE
DECLARATION OF CONFORMITY CE
3gb66072.fm Page 11 Tuesday, December 2, 2003 5:01 PM

12
INSTALLATION
ELECTRICAL CONNECTION
Important:
do not switch the oven on before the
connection is complete.
Make sure that the oven is installed by a skilled
electrician in accordance with the instructions
supplied by the manufacturer and in compliance with
the local regulations.
The installer is responsible for the correct electrical
connection and the observance of the safety
standards.
Fit an all-pole On/Off switch between the appliance
and the power supply with minimum contact
separation of 3 mm.
Earthing of the appliance is obligatory by law.
Do not use multiple sockets or extensions.
After installation the electrical parts must be
inaccessible.
Make sure that the mains voltage coincides with the
voltage shown on the appliance rating plate. The
rating plate is visible on the front edge of the oven
when you open the oven door.
Technical information for the installer
After unpacking the oven to connect it, rest it on the polystyrene base to avoid damaging it.
Do not lift the oven by the handle, but hold it by the sides.
Make sure that the appliance was not damaged during transport.
The oven and unit dimensions are shown in the figure at the side.
The units in contact with the oven must be heat-resistant (min. 85°C).
If the plastic laminates or the sealing material are not sufficiently heat resistant, this may result in the formation
of bubbles, deformation of the surface or detachment of the coating.
Insert the oven in the unit cavity, lifting it by the sides and being careful not to trap the power cable.
Fasten the oven using the screws.
The oven can also be built into a column.
 To allow for proper ventilation, leave an opening of at least 860x90 mm in the lower rear section of the
unit. If the product is installed in a column unit, in addition to the 860x90 mm opening at the base, leave
a 500x90 mm opening in the upper rear section of the unit.
3gb66072.fm Page 12 Tuesday, December 2, 2003 5:01 PM

13
BEFORE USING THE OVEN
For best use of this oven read the instructions for use
carefully and keep them in a safe place.
Remove the cardboard and polystyrene protection
from inside the oven.
Clean the inside of the oven with non abrasive soap
and warm water.
Remove the accessories from the oven and heat it at
the maximum temperature for about 30 minutes to
remove the odour and fumes from the insulating
material and the protective greases.
The window should be kept open during this
operation.
SAFEGUARDING THE ENVIRONMENT
1. Packing
The packaging material is 100% recyclable, as
confirmed by the recycling symbol .
2. Oven
The oven has been manufactured with recyclable or
reusable material. Dispose of it following the local
regulations for waste disposal. If the oven is to be
scrapped, cut off the power cable.
PRECAUTIONS AND GENERAL RECOMMENDATIONS
Before performing any maintenance, switch the oven
off.
 Keep children well away from the oven while it is
in use.
This appliance is not intended for use by young
children or infirm persons without supervision. Young
children should be supervised to ensure that they do
not play with the appliance.
Any repair or work on the oven must only be
performed by a trained electrician.
Make sure that electrical cables connecting other
kitchen appliances near the cooker cannot come into
contact with the hot parts or be trapped in the oven
door.
Wear oven gloves to remove pans and accessories
when the oven is hot.
 Never line the bottom of the oven with aluminium
foil.
Do not keep any inflammable items in the oven. If the
appliance is switched on by mistake, they could catch
fire.
Do not rest heavy weights on the door because they
could damage the oven cavity and the hinges.
Maximum weight: 7 kg.
Do not lean or sit on the open oven door.
Do not hang any weight on the handle of the open
oven door.
This appliance must only be used for the purpose for
which it was expressly designed, i.e. the cooking of
food. Any other use (e.g. room heating), should be
considered incorrect and thus dangerous.
The manufacturer declines all liability for injury to
persons or damage to property caused by incorrect or
improper use of the appliance.
The use of any electrical appliance implies the
observance of some fundamental rules. In particular
during use:
- do not take the plug out of the socket by pulling
the power cable;
- do not touch the appliance with wet or damp feet;
- do not use the appliance with bare feet.
3gb66072.fm Page 13 Tuesday, December 2, 2003 5:01 PM

14
OVEN ACCESSORIES
Drip tray 1
The drip tray is designed to collect fat and food particles when it is
positioned under the grid or as a plate, such as when cooking meat,
chicken and fish with or without vegetables. Pour water in the drip tray
to cover the bottom to reduce smoke and fat spatters.
Baking tray 2
To be used to cook biscuits, meringues and pizzas.
Shelf 3
To used to cook food or as a support for pans, cake tins or any other
cooking container. It can be positioned on any level available.
Catalytic panels 4
These panels are covered with a special microporous enamel which
absorbs the splashes of fat. We suggest performing a self-cleaning cycle
after particularly greasy cooking.
1. Switch the oven on empty to a temperature of about 200°C for
about an hour.
2. At the end of the cycle, when the oven is cold, use a damp sponge
to remove the food residues, if necessary.
Do not use soaps or detergents because these could ruin the
catalytic enamel.
A kit with the catalytic panels is available from the After-Sales Service.
Code No. 4812 310 28087.
Turnspit 5
To be used as indicated in the section of the separate Product
Description Sheet.
N.B.: The accessories vary depending on the model.
3gb66072.fm Page 14 Tuesday, December 2, 2003 5:01 PM

15
COOKING TABLE
Type of dish Temp.°C Side rail (*) Cooking time min. Cooking cycle
Pastry and cakes
Panettone or focaccia 180 2 55-65
Fruit pie 200 1 30-40
Ricotta pie 180 2 35-40
Cakes in a tin with yeast mixture 200 1 25-35
Shortcrust pastry 190 2 20-30
Choux pastry 200 2 15-25
Biscuits 190 3 15-20
Lasagne 225 2 40-50
Meat
Beef fillet 225 2-3 50-80
Beef roast 225 2-3 50-80
Veal roast 225 2-3 60-80
Lamb roast 225 2 45-55
Rare roast beef 225 2-3 50-60
Roast hare 200 2 60-90
Roast turkey 180 2 about 240
Roast goose 200 2 150-210
Roast duck 200 2 120-180
Roast chicken 200 2 60-90
Leg of goat 200 2-3 90-150
Leg of deer 180 2-3 90-180
Fish 180 2-3 10-40
Vegetables
Soufflé of cooked vegetables 170-190 2-3 40-50
Pizza 240 1 15-25
Cooking with the grill
Chops 4 8-12
Sausages 4 10-13
Grilled chicken 3 25-35
Chicken kebabs 50-65
Roast veal kebabs 50-65
Notes:
(*) The side rails are numbered from the bottom. Preheat the oven before putting the food in.
These cycles are recommended for cooking delicate foods and/or for reheating dishes.
This cycle is recommended for cooking several dishes and the same time without taste and smells
passing from one to the other (with the same cooking time).
THE DATA GIVEN ABOVE ARE INDICATIVE BECAUSE THE COOKING TYPE AND TIME VARIES WITH THE FOOD QUANTITY AND QUALITY.
3gb66072.fm Page 15 Tuesday, December 2, 2003 5:01 PM

16
CARE AND CLEANING
After using leave the cooker to cool and then clean it so that the
incrustations are not repeatedly heated.
If the dirt is stubborn, use a specific oven cleaning product
following the instructions on the package.
Clean the outside with a sponge dampened in warm water.
 Do not use abrasive or metal pads.
Clean the oven door glass with washing up liquid.
Wash the accessories in the dishwasher or by hand using an oven
cleaner.
Replacing the bulb
CAUTION: Disconnect the oven power supply cable.
To replace oven bulb B, remove protective cover Aby turning it
anticlockwise.
After replacing the bulb, refit protective cover A.
N.B.: Only use 25W bulbs, type E-14, T 300°C, available from the After-
Sales Service.
Oven door
The door glass can easily be removed and cleaned by unscrewing the 4
side screws.
Removing the oven door
To make it easier to clean the oven, the door may be removed.
The hinges Aare fitted with two mobile U-bolts Bwhich block the door
when it is completely open if they are hooked on to sections Cof the
hinges.
Lift the door and remove it holding the sides of the oven door
beside the hinges.
Refit the door by first sliding the hinges into their groves and,
before closing the door, detach the two mobile U-bolts Bwhich
were used to hook the two hinges.
3gb66072.fm Page 16 Tuesday, December 2, 2003 5:01 PM

17
TROUBLESHOOTING GUIDE
The oven does not work
Switch the appliance on again to check whether the
problem persists.
Check whether there is power to the oven.
Check whether the mechanical programmer has been
set on the cooking time or on the manual position.
AFTER SALES SERVICE
Before contacting AFTER SALES SERVICE:
1. Check whether you can deal with the problem without
help (see Troubleshooting Guide).
2. Switch the appliance on again to check whether the
problem persists.
If after these checks the oven does not work correctly,
contact the nearest After-Sales Service.
Please give:
a short description of the fault,
the exact type and model,
the service number (number after the word SERVICE
on the rating plate) located on the lower front edge
of the oven (visible when the oven door is open). The
service number is also indicated on the guarantee
booklet,
your complete address and phone number.
Repairs made under the guarantee always require the
intervention of the Manufacturer's authorised service
centres, as shown in the guarantee conditions.
In the event you need an intervention by technicians
not belonging to a manufacturer-authorised service
centre, make sure you are given a receipt showing the
work performed and make sure that the replacement parts
used were manufacturer's original parts.
Following these simple rules will guarantee the
product's quality and safety.
DECLARATION OF CONFORMITY CE
This oven is intended to come into contact with food
products and conforms with European Directive
89/109/EEC.
This oven has only been designed for use as a cooking
device. Any other use (such as heating rooms) is to
be considered improper and, as a consequence,
dangerous.
This oven (Class 3) has been designed, built and sold
in compliance with:
- the safety requirements of Gas
Directive 90/396/CEE;
- the safety requirements of Low Voltage
Directive 73/23/EEC;
- The protection requirements of EMC
Directive 89/336/EEC.
- The requirement of Directive 93/68/EEC
3gb66072.fm Page 17 Tuesday, December 2, 2003 5:01 PM