Whirlpool AKZ104IX01 User manual

3
INSTRUCTIONS FOR USE
SAFEGUARDING THE ENVIRONMENT
IMPORTANT NOTES
BEFORE USING THE OVEN
OVEN ACCESSORIES
CARE AND MAINTENANCE
TROUBLESHOOTING GUIDE
AFTER SALES SERVICE
To make the most of your new oven, read the user's instructions carefully and keep them on hand for
consultation in the future.
ENGLISH Instructions for use Page 3
3
11
3gb56231.fm Page 3 Tuesday, April 20, 2004 5:28 PM

4
SAFEGUARDING THE ENVIRONMENT
Disposal of packaging materials
The packaging material is 100% recyclable and is
marked with the recycle symbol .
Packing materials should therefore not be
thrown away with household rubbish but
disposed of as directed by local authorities.
Disposal of old appliances
The appliances have been manufactured with
recyclable or reusable materials. Disposal must
be carried out in accordance with local
environmental regulations for waste disposal.
Before disposing of them make them unusable
by cutting off the supply cable.
Energy saving
Only pre-heat the oven if specified in the
cooking table of the Product Description Sheet
or in your recipe.
Use dark, black enamelled baking moulds as they
absorb heat very well.
IMPORTANT NOTES
This oven is designed solely for use as a home
appliance for cooking food. Any other use is
forbidden. The manufacturer assumes no
responsibility for damage caused by improper or
incorrect use.
Any repairs or servicing must be carried out
exclusively by a qualified technician.
Never expose the oven to atmospheric agents.
Do not put heavy objects on the door because
they could damage the oven cavity and hinges.
Do not cling to the door.
Never hang anything heavy on the oven door
handle.
 Do not cover the bottom of the oven with
aluminium foil or other objects.
The oven door must close properly. The door
seals must be kept clean.
Do not pour water directly into the inside of a
hot oven. The enamel coating could be
damaged.
Fruit juice drippings from the baking tray may
leave permanent stains. We recommend the oven
be cleaned before reusing it.
Never drag pots and pans across the bottom of
the oven to prevent the coating from being
scratched.
Residual condensation after cooking could
damage the oven and surrounding kitchen units
in time. We recommend that you:
- set the lowest temperature;
- cover food;
- remove food from the oven;
- dry the wet parts when the oven is cool.
The front panel and the handle of the oven door
warm up when the appliance is switched on for
a long time at high temperatures.
Never touch the oven with any wet part of the
body and do not operate it with bare feet.
Do not pull the appliance or the power supply
cable to disconnect them from the electrical
supply.
 Keep children away from the following
elements as they are sources of danger:
- the oven and its controls, especially when in
operation and immediately afterwards to
avoid injury.
- packaging (bags, polystyrene, metal parts,
etc.)
- an oven to be scrapped.
3gb56231.fm Page 4 Tuesday, April 20, 2004 5:28 PM

5
Make sure that the electrical cables of other
appliances used near the oven do not touch hot
parts and are not trapped in the oven door.
Some oven models are equipped with an air
cooling system to prevent the front of the oven
and cabinet cavity from reaching excessively
high temperatures.
Attention: Steam and smoke are vented through
an opening located between the control panel and
the oven door. Do not obstruct the vent opening.
Do not place inflammable material in the oven or
nearby: a fire may break out if the oven is
inadvertently switched on.
Use oven gloves to remove pans and accessories,
when the oven is hot.
If alcoholic beverages are added when roasting
or cooking cakes and sweets (for example, rum,
cognac, wine, etc.) remember that alcohol
evaporates at high temperatures. It may happen
that vapours released by the alcohol can catch
fire when they are in contact with the electric
heating element.
Do not heat sealed containers in the oven
(except for packages specifically designed for
this purpose; see the manufacturer's
instructions). The pressure that develops inside
the packaging might cause it to explode,
damaging the oven.
Do not use containers made of synthetic
material for cooking (except for packages
specifically designed for this purpose; see the
manufacturer's instructions). They could melt at
high temperatures.
Keep an eye on the oven if you are using a lot of
fat or oil. Oil and fat can overheat and catch fire!
Never pull out fully loaded shelves. Use extreme
caution.
BEFORE USING THE OVEN
Remove the accessories from the oven and heat
it 200°C for about an hour to eliminate the smell
of the protective grease and insulating
materials. Keep the window open during this
operation.
Before using the oven, remove:
- stickers on the front and oven door, except
for the rating plate;
- cardboard protection and protective plastic
film from the front panel controls and other
parts of the oven;
- any sticky labels from the accessories
(for example, under the drip tray).
3gb56231.fm Page 5 Tuesday, April 20, 2004 5:28 PM

6
OVEN ACCESSORIES
Accessories supplied depend on the model. The accessories
provided with the oven are listed in the Product Description
Sheet provided separately (under Accessories).
Drip tray (1)
The drip tray is designed to collect fat and food particles when
it is positioned under the grid or as a plate, such as when
cooking meat, chicken and fish with or without vegetables.
Pour a little water into the drip tray to prevent spatters of fat
and smoke.
Baking tray (2)
For cooking biscuits, cakes and pizzas.
Grid (3)
The grid can be used to grill food or as a support for baking
trays, cake tins and other cooking receptacles. It can be placed
on any of the runners in the oven. The grid can be inserted with
its curved side facing upwards or downwards.
Side catalytic panels (4)
The catalytic panels have a special microporous enamel coating
that absorbs fat spatters. We recommend an automatic cleaning
cycle after cooking particularly fatty food (see Care and
Maintenance).
Turnspit (5)
Use the turnspit as indicated in the relevant chapter in the
Product Description Sheet supplied separately.
Kit Grill Pan Set (6)
The set comprises a grid (6a), an enamel drip tray (6b) and one
or two handles (6c).
This set must be placed on the grid (3) and used with the Grill
function.
1
4
5
6
2
6a
6b
6c
3
3gb56231.fm Page 6 Tuesday, April 20, 2004 5:28 PM

7
OVEN ACCESSORIES
CARE AND MAINTENANCE
Important: Do not use water pressure cleaners or
steam cleaners.
Exterior of the oven
Clean with a damp cloth. If it is very dirty, add
a few drops of washing up detergent to the
water. Wipe with a dry cloth.
Do not use corrosive or abrasive detergents,
which dull the surface.
In the event that one of these products comes
into contact with the oven, immediately clean it
using a damp cloth.
Slight differences in colour on the front of the
appliance are determined by the different
materials used, such as glass, plastic and metal.
Ovens with aluminium front panel
Clean using a delicate detergent and a soft
window cleaning cloth or a microfibre cloth that
does not leave fibres on the surface. Wipe
horizontally, without exerting pressure.
Do not use corrosive products, hard sponges or
rough cloths. Clean the aluminium surfaces with
a dry cloth.
Accessories
Soak the accessories in water with washing up
detergent immediately after use. Food residues
can be easily removed using a brush or sponge.
Oven cavity
Do not use abrasive cleaners or pan scourers. Use
special oven cleaners and follow the
manufacturer's instructions.
After every use, wait for the oven to cool then
clean it to prevent the build-up of baked-on food
residues.
With long cooking times or when cooking on
different levels, especially food with a high
water content (pizzas, stuffed vegetables, etc.)
condensation may form on the inside of the door
and the seal. When the oven is cool, dry the
inside of the door with a cloth or sponge.
Clean the glass of the door with a suitable liquid
detergent.
The oven door may be removed to facilitate
cleaning. To clean the upper part of the oven the
grill heating element can be lowered (only on
some models).
Self-cleaning catalytic side panels and rear
cavity (if provided) - Cleaning cycle
Heat the oven to 200° C when empty and
maintain this temperature for about an hour.
At the end of the cycle and when the oven has
cooled, use a damp sponge to remove any food
residues.
 Never clean the self-cleaning catalytic panels
and rear cavity with abrasive products, rough
brushes, pan scourers, or oven cleaner sprays,
as they will lose their automatic cleaning
properties.
Grease filter (7)
To be used for cooking fatty food only. Hook it onto the rear
wall of the cavity in front of the fan.
It can be washed in the dishwasher and must not be used with
the Fan function.
Sliding shelves(8)
They facilitate manual access during cooking and allow the
grids and drip trays to be pulled forward part way.
They are suitable for all accessories and can be washed in the
dishwasher.
7
8
3gb56231.fm Page 7 Tuesday, April 20, 2004 5:28 PM

8
Attention: When carrying out the following operations it is
advisable to wear protective gloves. These instructions
should be carefully followed both to prevent injury and in
order not to damage the oven door and hinges.
How to remove the oven door:
1. Open the oven door fully (see fig. 1).
2. Lift the two catches and push them forwards as far as they
go (see fig. 2).
3. Remove the door by closing it partially and pulling it
upwards (see fig. 3).
To remount the door:
1. Insert the hinges into their grooves and lower the door
fully.
2. Lower the two catches.
3. Close the oven door fully.
Attention: These instructions should be carefully followed both
to prevent injury and in order not to damage the oven door and
hinges.
To lower the grill heating element (certain models only)
Do not attempt to clean the oven until it is cool.
Remove the side runner grids.
Pull (4) the grill heating element slightly forward and lower
it (5).
5
4
2
1
3
3gb56231.fm Page 8 Tuesday, April 20, 2004 5:28 PM

9
Changing the rear oven lamp bulb (if provided):
1. Disconnect the oven from the electrical supply.
2. Let the oven cool before turning the lamp cover left to
unscrew it (see fig. 1).
3. Change the bulb (see note).
4. Screw the lamp cover back on.
5. Reconnect the oven to the electrical supply.
Note: use only 25 W/230 V, E-14 type, T300°C bulbs
available from After Sales Service.
Important: Do not use the oven until the lamp cover has
been repositioned.
Changing the side wall lamp
(if provided - depends on model):
1. Disconnect the oven from the electrical supply.
2. Let the oven cool before removing the left side runner grid
(see fig. 2). Using a screwdriver prise off the lamp cover
(see fig. 3 - 4).
3. Change the bulb (see note).
4. Reposition the lamp cover and press it against the oven wall
until it clicks correctly into place.
5. Remount the side runner grid.
6. Reconnect the oven to the electrical supply.
Note: use only 25 W/230 V, E-14 type, T300°C bulbs
available from After Sales Service.
Important: Do not use the oven until the lamp cover has
been repositioned.
Changing the side halogen lamp
(if provided - depends on model):
1. Disconnect the oven from the electrical supply.
2. Let the oven cool before removing the side runner grid
(see fig. 2). Using a screwdriver prise off the lamp cover
(see fig. 3 - 4).
3. Never replace bulbs with bare hands. Carefully remove the
halogen lamp from the ceramic holder and replace it with a
new one (see note).
4. Reposition the lamp cover and press it against the oven wall
until it clicks correctly into place.
5. Remount the side runner grid.
6. Reconnect the oven to the electrical supply.
Note: Use only 20 W/12 V, G4 type, T300°C bulbs, available
from After Sales Service.
Important: Do not use the oven until the lamp cover has
been repositioned.
2
3
4
1
3gb56231.fm Page 9 Tuesday, April 20, 2004 5:28 PM

10
TROUBLESHOOTING GUIDE
Oven not working:
Check for the presence of mains electrical power
and if the oven is connected to the electrical
supply.
Turn off the oven and restart it to see if the fault
persists.
IMPORTANT:
Check that the oven control knob is not turned
to 0 or to the lamp symbol .
- If the electronic programmer (depending on
model) display presents the message
 , consult the product description
sheet provided separately and/or the
electronic programmer description.
- If the electronic programmer (depending on
the model) presents the message FXX,
contact the nearest After Sales Service.
Specify in this case the number that follows
the letter F.
- Check that the mechanical programmer
(if provided) is turned to  .
AFTER SALES SERVICE
Before contacting After Sales Service:
1. Try to solve the problem yourself following the
points described in Troubleshooting Guide.
2. Turn off the appliance and restart it to see if
the fault persists.
If after the above checks the oven or cooktop
are still not working properly, contact the
nearest After Sales Service.
Please give:
A short description of the fault;
the oven type and model;
the service number (number after the word
Service on the rating plate), located on the
right hand edge of the oven cavity (visible
when the oven door is open). The service
number is also indicated on the guarantee
booklet;
your full address;
your phone number.
In the event the oven must be repaired, contact an
authorised After Sales Service, (use of original
replacement parts and proper repair is guaranteed).
Failure to comply with these instructions may
compromise the safety and quality of the
product.
DECLARATION OF CONFORMITY
 These appliances are intended to come into
contact with foodstuffs and they are
constructed in compliance with Directive
89/109/EEC.
 This appliance is designed to be used for
cooking only.
Any other use (for example, for room heating)
is considered as improper use and potentially
dangerous.
 The appliance was designed, manufactured
and sold in compliance with:
- The safety requirements of Low Voltage
Directive 73/23/EEC;
- the protection requirements of EMC
Directive 89/336/EEC
- the requirements of Directive 93/68/EEC.
3gb56231.fm Page 10 Tuesday, April 20, 2004 5:28 PM