Whirlpool RY160LXTB - 30" Ing Slide-In Electric Coil... Parts list manual

Slide-In Electric Range
PRODUCT MODEL NUMBERS OVERALL DIMENSIONS
CABINET OPENING DIMENSIONS
RY160LXT
Because Whirlpool Corporation policy includes a continuous commitment to improve
our products, we reserve the right to change materials and specifications without notice.
Dimensions are for planning purposes only. For complete details, see Installation
Instructions packed with product. Specifications subject to change without notice.
Electrical: When a 4-wire or 3-wire, single phase
120/240 volt, 60 Hz, AC only electrical supply is
available (or, if specified on the model/serial rating
plate, when a 4-wire or 3-wire single phase
120/208 volt 60 Hz, AC only electrical supply is
available), a 40- or 50-amp maximum circuit
protection is required, fused on both sides of the
line. A time-delay fuse or circuit breaker is
recommended. The model/serial rating plate is
located on the oven frame behind the storage
drawer panel.
*Range can be raised approximately 1" (2.5 cm) by adjusting the leveling legs.
**When installed in a 24" (61 cm) base cabinet with 25" (63.5 cm) countertop;
front of oven door protrudes 2-1/2" (6.4 cm) beyond 24" (61 cm) base
cabinet.
NOTE: 24" (61 cm) minimum when bottom of wood or metal cabinet is
protected by not less than 1/4" (0.64 cm) flame retardant (0.64 cm) flame
retardant 0.015" (0.4 mm) stainless steel, 0.024" (0.6 mm) aluminum or
0.020" (0.5 mm) copper.
30" (76.2 cm) minimum clearance between the top of the cooking
platform and the bottom of an unprotected wood or metal cabinet.
Cabinet opening dimensions shown are for 25" (64 cm)
countertop depth, 24" (61 cm) base cabinet depth and
36" (91.4 cm) countertop height.
If installing a range hood or microwave hood combination
above the range, follow the range hood or microwave hood
combination installation instructions for dimensional
clearances above the cooktop surface.
A. 30-3/4 " (78 cm)
B. 35-3/4 " (90.8 cm) height to
underside of cooktop edge
with leveling legs screwed all
the way in*
C. Model/serial number plate
(located behind the storage
drawer on the right-hand side
of the oven frame
D. 29-7/8 " (75.9 cm)
E. 28-5/16" (71.9 cm) from
handle to standoff at back of
range**
F. 23-3/4" (60.3 cm) countertop
notch to rear of cooktop
A. 13 " (33 cm) upper cabinet depth
B. 30 " (76.2 cm) min. opening width
C. For minimum clearance to the top
of the cooktop, see NOTE*.
D. 23-1/4" (58.1 cm) opening depth
E. 30 " (76.2 cm) min. opening width
F. Junction box - 5.5" (14 cm)
min. from either cabinet,
10" (25.4 cm) max. from floor.
Outlet must be flush. Nothing
located in shaded area can
extend more than 2" (5.1 cm)
from wall or range will not
slide all the way back
G. Cabinet door or hinge should
not extend into cutout
Ref. 8101P746-60
08-13-07
®
C
B*
A
D
E**
F
A
B
C
D
E
F
G