Whirlpool AKR610WH User manual

7
CONTENTS GB
To get the best performance from the hood, please read these user instructions carefully
BEFORE USING THE HOOD PAGE 8
PROTECTING THE ENVIRONMENT PAGE 8
GENERAL TIPS AND SUGGESTIONS PAGE 8
HOW TO USE THE HOOD PAGE 9
CARE AND MAINTENANCE PAGE 9
TROUBLESHOOTING GUIDE PAGE 9
AFTER SALES SERVICE PAGE 10
INSTALLATION PAGE 10
75004Agb.fm5 Page 7 Tuesday, March 27, 2001 10:55 AM

8
• To get the best performance from the
hood, please read these user
instructions carefully.
•Packaging materials must be kept out
ofchildren’s reach as they are potentially
dangerous. Keep the packaging material
(plastic bags, polystyrene, etc.) well out of
their reach.
•Make sure the hood has not been damaged
during transportation.
•Installation and connection to the mains and
exhaust ducts must be carried out by a
qualified technician, in accordance with the
manufacturer's instructions and local
safety regulations.
1. Packaging
The packaging is marked with the recycling
symbol, signifying that it can be 100%
recycled . Dispose of the packaging in
conformity with environmental regulations.
Packaging materials must be kept out
ofchildren’s reach as they are potentially
dangerous. Keep the packaging material
(plastic bags, polystyrene, etc.) well out of
their reach.
2. Appliance
The appliance is made from recyclable
materialsandmustbescrappedinaccordance
with local waste disposal regulations.
Make the appliance inoperable by
unplugging it and cutting off the power cable.
Follow local waste disposal regulations
when scrapping.
1. Always disconnect the hood by switching
off the electrical power supply before
cleaning or carrying out maintenance.
2. Exhaust air must not be conveyed through
the same flue used by the heating system or
other non-electrical appliances.
3. Do not flambé food under the hood since
the flames generated could cause
a fire.
4. Never leave the pan unattended when
frying as the cooking oil could ignite.
5. Regular maintenance guarantees smooth
hood operation and high performance.
6. If the hood is used together with
non-electrically powered appliances,
ambient negative pressure must not exceed
4 pa (4 x 10-5 bar).
For this reason, make sure the room is
well ventilated.
7. Regularly remove dirt deposits.
Regularly clean or replace filters.
Never use flammable materials to convey
exhaust air.
Declaration of conformity
This appliance has been designed, built and
marketed in compliance with:
-the safety requirements of the “Low Voltage”
EEC Directive 73/23;
-the protection requirements of the “EMC”
EEC Directive 89/336 amended by
EEC Directive 93/68.
BEFORE USING THE HOOD
PROTECTING THE ENVIRONMENT
GENERAL TIPS AND SUGGESTIONS
75004Agb.fm5 Page 8 Tuesday, March 27, 2001 10:55 AM

9
Switch on the hood a few minutes before starting
tocookandleaveitrunningforatleast5 minutes
after you have finished.
1. Pull out the steam deflector (depending on
model). This improves hood performance.
2. Turn the speed selector to the required
speed setting according to the quantity of
fumes and steam to be extracted.
3. Switch off the hood 5 minutes after you have
finished cooking.
4. Close the steam deflector (where fitted).
Always disconnect the hood by switching off the electrical power supply before
cleaning or carrying out maintenance.
Grease filter
• The sponge grease filter should be
washed in hot soapy water once a month
(soak for 1-2 hours, do not wring.
If necessary, repeat the process.
Replace with a new filter every 5-6 washes).
• The grease filter paper should be replaced
at least once a month.
• Grease filter paper with indicator should
be replaced at least every two months or
whenever the colour becomes visible
through the holes of the grille.
The paper filter is coloured on one side.
This colour should not be visible through the
grille holes when the filter is installed.
• The metal grease filter has an unlimited life
and should be washed once a month
by hand or in a dishwasher (60°C) with
appropriate detergents.
Leave filter to dry, handling it carefully
before remounting it.
Whenever cleaning or replacing the grease
filters, clean all other exposed parts of the hood.
Carbon filter
(“Air recirculation mode”, see following
page)
The carbon filter cannot be washed or
regenerated.
Replace the carbon filter (normal usage)
every 6 months (Rectangular carbon filter)
every 4 months (Circular carbon filter)
Replacing the bulbs
1. Pull out the steam deflector
(depending on model).
2. Open the grille or light fixture and remove the
grease filter.
3. Removetheburnt-outbulbandreplaceitwith
a new one of the same wattage. Close the
grille, light fixture or metal grease filter.
Cleaning the hood
Use a soft cloth with methylated spirits or a mild
liquid detergent. Never use abrasives.
Warning!
Failure to observe the instructions for
cleaning the appliance and replacing or washing
the filters may cause a fire.
Hood does not work:
•Is the electrical power supply switched on?
•Is there a power failure?
•Has the fuse blown?
Insufficient suction power:
•Did you set the right speed?
•Do the filters need to be cleaned or replaced?
•Are the air outlets blocked?
Light does not work:
•Does the bulb need to be replaced?
•Is the bulb correctly fitted?
•Has the fuse blown?
Never try to carry out any repair
yourself other than fixing the
above-mentioned problems.
HOW TO USE THE HOOD
CARE AND MAINTENANCE
TROUBLESHOOTING GUIDE
75004Agb.fm5 Page 9 Tuesday, March 27, 2001 10:55 AM

10
Before calling After Sales Service:
1. Check to see if you can fix the problem
yourself (see “Troubleshooting guide”).
2. Switch off the hood for a few minutes and
re-startitto see if theproblemhascleareditself.
3. If the malfunction persists, call
After-Sales Service.
Specify:
•The nature of the problem.
•The model.
•Theservicecode(number below
the word SERVICE on the rating
plate inside the hood behind the
grease filter).
•Your full address.
•Your telephone number and area code.
When installing the hood, the minimum distances from the cooktop must be respected, and
the numerical sequence and additional instructions must be followed exactly as indicated on
the Installation sheet.
EXTERNAL EXHAUST MODE
(A- see also instruction sheet)
Cooking fumes and vapours are conveyed
outside through a duct connected to the hood by
means of a collar.
The outlet duct diametermust be the same as
that of the collar.
If a flue-damper is to be installed, check that
it can open and close freely when installation
of the exhaust duct is complete.
The hood can be supplied with one (upper) or
two (upper and rear) exhaust outlet holes.
The hood is usually set up for using the
upper exhaust outlet.
1. The collar must be seated in the upper
exhaust outlet.
Use the rear exhaust outlet (where present).
1. Wherefitted, remove the coverclosingoffthe
rear outlet and collar.
2. Some models are fitted with a plastic
deflector that closes off the rear outlet.
If fitted, remove it.
3. Fit the collar in the rear outlet.
4. Put the cover (if fitted) in the upper outlet.
Warning! If the hood has a carbon filter, this
should be removed.
Check that the switch inside the hood (if fitted)
is in position “A” Extractor; if not, set it to
this position.
AIR CIRCULATION MODE
(F- see also installation sheet)
The air is filtered by a carbon filter and recycled
into the surrounding atmosphere. The filtered air
is released towards the kitchen ceiling.
Warning! If the hood does not have a carbon
filter, order one and fit it before use.
Check that the switch inside the hood (if fitted) is
on position “F” Filter; if not, set it to this position.
If the plug is provided, close off the upper
exhaust hole.
ELECTRICAL CONNECTION
Before connecting the hood, make sure the
voltageindicatedontheratingplatecorresponds
to the voltage in your home.
The plate is located inside the hood behind
the grille.
For GB this appliance is supplied without a plug
and is intended for direct connection to fixed
wiring in accordance with national wiring
regulations. An all-pole disconnection switch
witha minimumcontactseparationof3 mmmust
be included in the fixed wiring in an easily
accessible position.
The Manufacturer shall not be liable for
any damage or problem arising from
the failure to comply with the
above-mentioned instructions.
AFTER SALES SERVICE
INSTALLATION
75004Agb.fm5 Page 10 Tuesday, March 27, 2001 10:55 AM