Wilko WUA150 User manual

WUA150
cable trunking
instructions
464491 rev00

Please Read
Retain all packaging in case the product needs to be returned.
Contents may vary from photography/ Illustrations.
This product is intended for indoor use only. Use of this product outdoors could lead to failure and
personal injury.
It is the responsibility of the installer to ensure that the mounting wall is of a suitable standard and
void of any services (eg gas, electricity, water etc).
Please read the hints and tips below to help you with the application of your cable management.
Tools Recommended
i
i
ii
iii
iv
v
Ensure you roll wall strip A and cover strip B smoothly and evenly to prevent creasing.
Ensure both wall strip A and cover strip B are as flat as possible before attaching to the wall.
Ensure the surface you wish to attach the cable management to is clean and dry.
Ensure that before you attach wall strip A you are happy with the position.
Ensure when you attach wall strip A to the wall that you press firmly and that you remove all
air bubbles, repeat after 5 minutes.

Boxed Parts
A
B
x1
x1
Cover Strip
Wall Strip
Step 1 Unpack
B
A
Leave wall strip A in the
cardboard packaging until
you have straightened and
uncurled cover strip .B
!
Care must be taken when
unpacking product as
it can spring open

Step 2 Uncurling and Flattening
When uncurling and flattening wall strip A and
cover strip B, put the roll between your knees to
keep the roll steady while you roll the strip back
on itself.
We recommend this action is performed a
minimum of 3 times to get the required result.
i
Start
End
End
ii
iii
Start
End
Care must be taken when uncurling and flattening as product can spring open
!
When cover strip B is
uncurled and flattened
repeat for wall strip A
Be careful not to crease, roll smoothly and evenly.
!
B

Step 3 - Measuring and Cutting
Measure and cut wall strip A and cover strip B

Step 4 - Attaching Wall Strip A
Remove backing paper from the self
adhesive strips on wall strip A.
ii
Before you attach wall strip A, use a clean,
slightly damp cloth to clean the surface, let
it dry thoroughly. Failure to do this will
result in poor attachment.
i
!Before you attach wall strip A, make sure you are happy with the position
A
iii
iv
Using a spirit level as a guide, carefully
stick wall strip A to the wall.
Using a clean, dry cloth firmly press and rub
up and down in the channels to ensure all
air bubbles have been removed from wall
strip A. Repeat to ensure
wall strip is firmly attached to the wall.
after 5 minutes
A
Channels
A
A

Shop online wilko.com
PROMISE
Shop with confidence. If not completely satisfied, simply return this product with the receipt,
within 28 days, and we’ll gladly exchange it or refund you. That’s a promise.
This does not affect your statutory rights.
Produced in China for Wilkinson, Roebuck Way, Manton Wood, Worksop,
Nottinghamshire, S80 3YY
Careline 0333 320 7024
All measurements are approximate. Images are for illustration only.
Step 5 - Attaching Cover Strip B
If you desire you can paint your cable management to suit
your decor for an even more stylish, low key finish.
i ii iii
With cables in place, hook
one side of cover strip B
into wall strip A.
With the top of cover strip
B in place you will be able
to hook the rest of cover
strip B into place by firmly
squeezing and sliding your
thumb downwards.
Working from the top,
squeeze cover strip B so the
other side hooks into place.
You can tie a piece of string around your cables at the top and bottom to make it
easier to attach cover front strip B.
Step 6 - Finishing Touch
A
B B B