Williams Sound PPA R1600 User manual

FM Remote Speaker
• Model PPA R1600
FM Remote Speaker • Model PPA R1600
©2007, Williams Sound Corp. MCAT 060C 1
NOTE: SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE!
Description:
The FM Remote Speaker, model PPA R1600, allows a group of people to listen to the FM broadcast in
a cry room, nursery, office area, or any location where a remote speaker is needed and wiring is diffi-
cult to run. The R1600 features 16 selectable channels on 72-76 MHz, mic and line-level inputs, and
will operate up to 1000 ft (304.8 m) when used with the Williams Sound T35 transmitter
Applications:
Houses of Worship • Conferences • Auditoriums • Music Applications
Dimensions: 12.4"H x 7.1"W x 7.5"D (315mm x 180mm x 190mm)
Color: Black with white legends
Weight: 9.4lb (4.3kg) approx. with SLD 072 receiver
Rated Power: 20 watts continuous
Frequency Response: 65Hz – 7kHz
Max SPL @ rated output: 101dB @ 1 meter
Woofer: 5.25" (133.35mm) high efficiency magnetically shielded
Tweeter: 1" (25mm) dome
Crossover: 1st order passive @ 8kHz
Tone Control: -6dB/octave sliding lowpass (3kHz to 8kHz)
Wireless inputs CHANNEL A: SLD 072 FM Receiver, 72-76 MHz*
Operating Freq: 72.1, 72.3, 72.6, 72.8, 74.7, 75.4, 75.7, 75.9, 72.5,
72.2, 72.4, 72.7, 72.9, 75.3, 75.6, 75.8 MHz.
Intermediate Freq: 10.7 MHz
FM Deviation: ± 75 kHz max
Sensitivity: 2 uV at 12 dB SINAD with squelch defeated
Input Overload: 20 mV
Frequency Response: 65 Hz to 7 kHz ± 3 dB
Signal to Noise ratio: 60 dB at 100 uV
Antenna connector: Thread mount for ANT 028 telescoping
antenna. 75 ohms.
CHANNEL B: Empty slot for additional receiver sled
Wired inputs/output
Mic: -81dBV (0.089mVRMS) for 1 watt 100KΩunbalanced, 1/4 " phone
jack, variable
Line: -40dBV (10mVRMS) for 1 watt 10KΩunbalanced, RCA jack, variable
Line-Out: +15dBV max - RCA jack
AC Power Requirements: User switchable
110-125 / 210-240VAC - 50Hz / 60Hz
Approvals: UL, C-UL, FCC, RoHS, WEEE
Included w/speaker: Removable wall-mount bracket with 2 screws and rubber anti-
rotate pads, removable right-angle AC cord, 4 self-adhesive anti-
skid pads, 4 module screws, 1 noise-canceling circuit boards per
receiver sled installed
PPA R1600 Remote Speaker:
PPA R1600 Front View
PPA R1600 Back View
*DISCLAIMER: FCC RULES LIMIT USE OF THIS EQUIPMENT TO AUDITORY ASSISTANCE
FOR THE HANDICAPPED.

FM Remote Speaker
• Model PPA R1600
FM Remote Speaker • Model PPA R1600
©2008, Williams Sound Corp. MCAT 060C 2
Bid Specs:
PPA R1600
The Williams Sound Corp. PPA R1600 shall be a powered speaker and have a sixteen channel wideband
72-76 MHz receiver that can be accessed on the back of the unit. It shall be housed in a black heavy
duty plastic enclosure 12.4” x 7.09” x 5.6” and weigh approximately 9 lbs.
The R1600 shall have a 20 watt amplifier and two way speaker system with a 5.25” magnetically shield-
ed woofer and a 1” dome tweeter.
The R1600 shall have an RCA line input, RCA line output and 1/4” low impedance microphone input. It
shall have separate microphone and line in level adjust and have a master tone and volume rotary
adjust.
The receiver sled shall have a 75 Ohm antenna output, on/off audio level rotary adjust, RF rotary
squelch adjust and sixteen position rotary channel selector. The R1600 shall be supplied with a 39 inch
telescopic antenna.
The R1600 shall be supplied with a wall mount bracket and have the ability to be mounted on a micro-
phone stand (not supplied).
It shall be AC powered and have 230 - 115VAC switch on the back and be UL, C-UL, FCC, RoHS, and
WEEE compliant.
The R1600 shall have a five year warranty and be called the Williams Sound Corp. PPA R1600.
SLD 072
The SLD 072 receiver sled shall be a sixteen channel wide band 72-76 MHz receiver designed specifically to
work with the PPA R1600 powered speaker/receiver. It shall be enclosed in a metal housing 5” x 5” x 1”
and weigh 0.62 lb.
It shall have a sixteen channel rotary channel select, rotary on/off audio level control, rotary squelch con-
trol, a 75 ΩF-connect antenna output and an RF LED indicator showing when the receiver is receiving an
FM signal.
The SLD 072 is designed to slide into the back of the PPA R1600 and shall be locked in place by two
thumb screws on the face plate.
The SLD 072 shall have a deviation of ±75 kHz, frequency response 40 - 15 kHz and S/N ratio of 60 dB
when used with the PPA T35.
The SLD 072 shall be FCC, RoHS and WEEE compliant.
The receiver shall have a five year warranty and be called the Williams Sound Corp. SLD 072.
NOTE: SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE!
*90 days on accessories.

FM Remote Speaker
• Model PPA R1600
FM Remote Speaker • Model PPA R1600
©2008, Williams Sound Corp. MCAT 060C 3
NOTE: SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE!
United States
Williams Sound Corp.
10321 W. 70th Street
Eden Prairie, MN 55344
Ph: 800-328-6190 / 952-943-2252
FAX: [phone]
Email: [email protected]
Web: www.williamssound.com
Canada
Thorvin Electronics
2861 Sherwood Heights Dr. Units 36-37
Oakville, ON L6J-7K1 Canada
Ph: 800-323-6634 / 905-829-3040
FAX: [phone]
Web: www.thorvinelectronics.com
Asia, Australia, Latin America, Middle East, South Africa
International Sales Department
Williams Sound Corp.
10321 W. 70th Street
Eden Prairie, MN 55344 USA
Phone: [phone]
Fax: [phone]
Email: [email protected]
Web: www.williamssound.com
Contact: