Williams Symphony User manual

Laying the Pedal Cable
Take off the cable slot cover. Lay in
the pedal cable from the pedal crossbar,
then insert the cover.
Tools required: phillips screwdriver
Ten M6X20 screws
Four M6X15 screws Six 4X16 self-tapping screws
Two 4X12 self-tapping screws
Cross Bar Installation
Attach the pedal crossbar to the leg
with the M6X20 screws.
Check the Package Contents
Assembly

Backboard Installation
Attach the back board to the legs with
M6X15 and 4X16 screws.
Final Installation
Place the piano body on the assembled
stand and attach it with the M6x20
screws. Install the headphone holder in
the proper location with the screw 4X12.
Plug the pedal connector into the
socket on the bottom.
Power Supply Connection
Plug the power cord into the receptacle located
on the bottom of the piano. Plug the 3-pin
plug into the socket and the other end of the
cord to the AC wall outlet.
Headphone
Holder