Winegard Ds-3000 User manual

Winegard Company

3000 Kirkwood St., Burlington, IA 52601-2000

Printed in U.S.A. © Winegard Company 1998

WINEGARD

Pipe Mount Kit

Model DS-3000

WARNING

INSTALLATION OF ANTENNAS NEAR POWER LINES IS DANGEROUS.

FOR YOUR SAFETY, FOLLOW THE INSTALLATION INSTRUCTIONS.

INSTRUCTIONS

NOTE: This mount is designed to fit on the

side of a house. Either end of the mast can be

attached to the base, depending on how much

clearance is required for the antenna.

NOTE: Lag bolts not supplied.

NOTE: Not recommended for antennas with a

boom length longer than 40".

STEP 1. Locate a stud in the area to be installed.

STEP 2. Drill a small pilot hole, to help start

threading the lag bolts (5/16 x 3" recommended).

STEP 3. Apply silicone sealant to back of the

base to seal holes.

STEP 4. Using lag bolts tighten the base to the

wall. Make sure mast is plumb.

Do not overtighten.

You can deform the mast.

Tighten securely when

mast is plumb.

Stud

Lag Holes (5/16 x 3" lag

screw recommended)

Make sure mast is plumb.

If siding is heavy enough

these holes can also be

used to help secure the

base.

HOW TO PROVIDE LIGHTNING

PROTECTION

FOR TV ANTENNA AND SET

STEP 1. Mount the lightning arrestor as close

as possible to where the downlead enters the

house.

STEP 2. The ground wires for both the mast

and the downlead should be copper or

aluminum wire, number eight (8) or larger.

STEP 3. The downlead wire from the antenna

to the lightning arrestor should be secured

every four (4) to six (6) feet to prevent

whipping.

NOTE: In the case of a "ground up" antenna

installation, it may not be necessary to ground

the mast if the mast extends four or more feet

into the ground. Consult a TV serviceman for

proper depth in your location.

90 DAY LIMITED WARRANTY

Winegard Company warrants this Winegard product against any defects in materials or workmanship within 90 (ninety) days from date of purchase. No

warranty claim will be honored unless at the time the claim is made, you present proof of purchase to an authorized Winegard dealer (if unknown, please

contact Winegard Company, 3000 Kirkwood Street, Burlington, IA 52601-2000, Telephone 800-288-8094).

Winegard Company (at its option) will either repair or replace the defective product at no charge to you. This warranty covers parts, but does not cover any

costs incurred in removal, shipping or reinstallation of the product. This limited warranty does not apply if the product is damaged, deteriorates, malfunctions or

fails from: misuse, improper installation, abuse, neglect, accident, tampering, modification of the product as originally manufactured by Winegard, usage not in

accordance with product instructions or acts of nature such as damage caused by wind, lightning, ice or corrosive environments such as salt spray and acid rain.

The 90 Day Warranty is provided on the condition that the equipment is properly delivered with all handling and freight charges prepaid to your Winegard

dealer for return to our factory for repair or replacement. Winegard dealers will arrange for the replacement or repair and return to you without charge the

product which failed due to defective material or workmanship.

WINEGARD COMPANY WILL NOT ASSUME ANY LIABILITIES FOR ANY OTHER WARRANTIES, EXPRESS OR IMPLIED, MADE BY ANY OTHER

PERSON.

ALL OTHER WARRANTIES WHETHER EXPRESS, IMPLIED OR STATUTORY INCLUDING WARRANTIES OF FITNESS FOR A PARTICULAR PURPOSE

AND MERCHANTABILITY ARE LIMITED TO THE 90-DAY PERIOD OF THIS WARRANTY.

The foregoing shall be the sole and exclusive remedy of any person, whether in contract, tort or otherwise, and Winegard shall not be liable for incidental

or consequential damage or commercial loss, or from any other loss or damage except as set forth above.

Some states do not allow limitations on how long an implied warranty lasts, or the exclusion of limitation of incidental or consequential damages, so the

above limitations or exclusions may not apply to you.