
c
lag holes
(5/16"x 3" lag screw
recommended)
stud
If siding is heavy enough, the
outer holes can also be used
to help secure the base.
a
b
Universal Mount w Adapter Plate DS2000S Quick Start Guide
INSTALLATION
Printed in U.S.A. © 2022 Winegard Company
Rev 9-22 2452507
Starlink is a trademark of Space Exploration Technologies Corp. All trademarks, registered trademarks and logos
are the property of their respective owners and are not aliated with Winegard Company.
1LOCATE a stud in the area to be
installed.
2DRILL a small pilot hole to help start
threading the lag bolts (5/16"x 3"
recommended) (a).
3APPLY silicone sealant to the back of
the base to seal holes (b).
4USE the lag bolts to tighten the base to
the wall. Make sure the mast is plumb.
5INSERT the U-bolts through the slots
in the adapter plate and secure loosely
with the nuts (c).
6POSITION the adapter plate facing
UP, and place the bottom U-bolt over
the antenna mount pipe (c). Tighten
the two bottom U-bolt nuts.
7SLIDE the auxiliary pipe through the
upper U-bolt and into the antenna mount
pipe as far as possible (d). The second
guide rests on the top edge of the pipe
mount. Tighten the nuts on the upper
U-bolt until the pole is secure. Verify the
bottom U-bolt is also secure.
WARNING:
INSTALLATION OF THIS PRODUCT
NEAR POWER LINES IS DANGEROUS. For
your safety, follow the installation instructions.
See back for grounding instructions
1.0"– 1.5"
auxiliary
pipe dia.
or Starlink
CONTENTS:
2 - U-bolts
1 - Adapter plate
4 - Flanged hex nuts
1 - Pipe & foot assembly
d
Not provided: 7/16"wrench, lag bolts
SCAN
FOR
WARRANTY
OR CALL
800-288-8094
Winegard Company 2736 Mt. Pleasant St. |Burlington, IA 52601
MORE
PRODUCT
INFORMATION