Winsome house WH138 User manual

Instruction, Use & Care Manual
Please save this manual for
future reference.
Thank you for purchasing this Winsome House product. This product has been manufactured with the highest standards of
safety and quality.
This instruction and product manual applies to multiple items.
Product Item #s: WH138 (pre-lit), WHAP341 (no lights), WHAP342 (pre-lit)
Product Description: Artificial Christmas Tree
ASSEMBLY AND INSTALLATION INSTRUCTIONS
1. WARNING - Risk of Fire and Electric Shock.
2. Read all instructions and warning tags included with this tree.
3. Do not place near fireplaces, candles, outdoor heaters, or other similar sources of heat. This item is not flame
retardant.
4. Do not install near pools, fountains, tubs, sinks, or other areas of standing water that the tree may fall or blow into.
5. Disconnect tree’s light sets from power before starting.
6. Keep wires clear of being pinched or cut during assembly or installation. Discard sets with cut or pinched insulation.
7. Do not press or grasp bulbs during assembly or installation.
8. Make sure final assembly stable enough to hold the tree upright.
9. Do not use candles on tree. Use only with the included mini lights.
10. Do not overload extension cords or power strips.
11. Always fully insert electrical plugs into a receptacle.
12. This product is for decoration use only. Not to be used by children as a toy. Keep out of reach of small children.
No tools required for assembly.
Before You Start
1. Decide on an appropriate location for your product, please read assembly and Instruction procedure carefully.
2. Retain the instructions for future use and save the carton for storing your tree.

Instruction, Use & Care Manual
Please save this manual for
future reference.
Product Item #s: WH138 (pre-lit), WHAP341 (no lights), WHAP342 (pre-lit)
Assembly and Instruction Procedure:
Every carton should contain a top section and a bottom section (larger trees include middle sections).
This will depend on what model you have purchased. Also included is a metal base. Remove all Packaging (i.e. cardboard or
plastic) before beginning.
1. Choose a location where the tree is to be displayed. Take out the tree stand. Metal stand unfold as “X” shaped as Figure
1, place it on a flat surface.
2. Insert the pole with tapered end of the tree bottom into the tree stand and tighten the 3 screws on the stand.
3. Insert the middle tree section into the tree bottom and push down into position. (Note: This does not apply to trees
with only 2 sections.)
4. Insert the tree top into the middle tree section and push down into position as Figure 2.
5. Gently lower all main branches on tree sections (figure 3). Take care not to place unnecessary pressure on the brackets
when assembling. The branches on your tree can be adjusted to give tree the desired amount of fullness. For best
results, straighten and separate all branch tips, then bend them slightly upward (figure 4).
6. CONNECTING THE STRINGS WITH POWER (see Figure 2): If there is power supply cord, please find the power supply
cord on the bottom section. Follow the method below: carefully connecting the plug to end-connector by A to A, and B
to B. And then plug tree lights into a power outlet.
YOUR TREE IS NOW READY TO ENJOY!
Figure 4
Figure 3
Figure 2
Figure 1

Instruction, Use & Care Manual
Please save this manual for
future reference.
Product Item #s: WH138 (pre-lit), WHAP341 (no lights), WHAP342 (pre-lit)
Storage:
1. Warning – Disconnect power from the lights.
2. Remove all decorations.
3. Starting from the top, carefully remove branches. Press the tips back up against the stem.
4. Place the branch sections back into the carton, putting the longest one on the bottom.
5. Store the product in a cool, dry location protected from sunlight where the temperature does not exceed 35˚C (95˚F).
MADE IN CHINA