www.snapav.com Support: 866.838.5052
pg. 2
WPS-MNT-L-DOM Installation Manual
Installation
Important Note: To avoid damaging the dome surface during installation, keep the dome surface
away from walls and other objects. Do not remove the protective coating from the dome until
after the camera is mounted and the dome installed.
Microfiber or similar cloths can be abrasive, only use a dry eyeglasses cloth when cleaning the
lens to avoid damage that can blur the cameras image.
1. Install the Camera Wires into the Mount and Arm
2. Attach the Camera to the Mount
A. Remove the Camera Mount Plate (A) from the
L Bracket (B). Set the L Mount to the side.
B. Insert the wires from the camera through the
wire hole in the Camera Mount Plate (A) and
through the hole in the L Mount (B) pulling out
of the rear of the L Mount.
Tip: Placing the BNC Video Out in rst makes the
process quick
C. Secure the Camera Mount Plate (A) to the L
Mount (B) using the 4 M3x4 Pan Head screws
(I); ensure that it is fully tightened.
A. Remove the dome from the Camera Base
using the 3mm Allan key supplied with the
camera. Avoid contact of the dome with
surfaces in order to avoid scratching the dome
material.
B. Place the Camera Base on the Camera Mount
Plate (A) orientated as shown in Figure 2.
Tip: Inserting a mounting screw into the Camera
Base and then into the Camera Mount speeds up
the alignment process.
C. Secure the Camera Base to the Camera
Mount Plate using all 3 provided M4x10L Round
Head Philips (L) screws with rubber washers.
Note: To avoid moisture from entering the camera; ensure that the rubber grommets are on the screws during
installation
D. Loosely attach the dome onto the Camera. Note that you need to remove this later to setup the
camera once it is fully mounted. The assembly is now ready to be mounted to the wall.
Figure 1
Camera Base
*Note orientation of Camera Base and Camera
Mounting Plate. Identified holes must line up.
Figure 2
Align Holes*
Camera Mount
(bottom)
Camera Conduit
Connection
