2/3
1”/26mm Adapter Sleeve (2A)
11
/
2”/32mm Adapter Sleeve (2B)
2”/38mm Adapter Sleeve (2C)
Pole Alignment Insert (3)
Filler Cap (4)
Carrying Indent
Carrying Indent
Water Base Body (8)
Optional Nylon Roller Kit (10)
Hand Wheel (5)
Stainless Steel Pole Stand (1)
3 x M8 washers and M8x16 bolts (6)
1) From the bottom of the water base body (8)
slide the pole stand (1) in and up until its base sits
ush with the water base body underside (8).
2) Insert the 3 M8 washers and bolts (6) into the 3
holes under the pole stand triangular base and
tighten using the supplied allen key.
3) Slide the pole alignment insert (3) from the top
of the pole tube down inside it until it sits at the
base of the tube.
4) Insert the required adapter sleeves (2A, 2B, 2C)
into the top of the pole tube, aligning them until
the notch is centred to allow the hand wheel hole
to line up.
5) Insert the hand wheel (5) into the bolt hole on
the side of the pole stand (1), do not tighten until
the umbrella pole is positioned in the pole stand,
only then should you tighten to ensure the
umbrella pole is xed in place.
OPTIONAL NYLON ROLLER KIT ASSEMBLY:
1) If you have purchased the option Nylon Roller
Kit (10) it should ideally be attached to the water
base body before you assemble the pole tube
and the ttings. You will nd it in a separate bag
or box.
2) Turn the water base over and place the nylon
roller and bracket into position within the
carrying indent with the two threaded holes on
either side.
3) Insert the 2 x M8 washers and 2 x M8x16 bolts
and tighten them into place.
4) The water base can now be easily repositioned
by simply tilting it onto the roller and pushing it
into the required place.
Nemo Water Base 10 March 2021
