Woodstock Soapstone Cottage Franklin User manual

Cottage Franklin Burner Tile Replacement
Please read all the instructions before you begin the procedure. Confirm that
you have all the necessary tools and materials. If you have any questions
technical support is available toll free at 1-800-866-4344, Monday-Saturday
9:00-5:00 ET.
Tools needed:
-Needle nose pliers or wire window clip tool (included with stove)
-Vacuum
Materials needed:
-Replacement burner tile part# G-91
1. Make sure that the stove (including pilot light) is off and cool. Turn off
the gas supply at the appliance shut off valve.
2. To remove the front casting, lift straight up, swing the bottom of the
casting outward and then pull down and away from the stove.
3. Use pair of pliers or the window clip tool that came with your stove to
release the two window clips. Pull them out and twist them out of the
way.

4. Remove the glass window and frame assembly by pulling the window up
out of the bottom glass retainer and out away from the stove.
5. Use extra care when removing the log set as it is very fragile. First,
remove the log at the rear of the log set by lifting it up off the pins in the
base and out of the stove.
6. Carefully lift the log set out of the stove by the base of the log set. Do
not pull up on any of the smaller logs as they will separate from the base.

7. Now pull the original tile off the top surface of the burner pan.
8. Clean any debris from the surface of the burner pan with a vacuum.
9. Place the new tile on the burner pan. The alignment of the holes in the
tile and burner pan is very important to flame appearance and stove
performance. It may be necessary to bend the side rails of the burner pan
slightly to hold the tile for proper alignment.

10.Carefully place the log set back on the burner. Ease it as far forward and
to the left as possible. Log placement is critical for the best flame
appearance and stove performance. Improper alignment can cause tall,
stringy flames or short flames. It can also create excessive carbon and
soot buildup on the log set and firebox.
11.Insert the rear log over the pins in the base of the log set.
12.Install the glass window and frame assembly by placing the bottom edge
into the glass retainer and center it to the firebox. Pull out on the window
clips with pliers (or the window clip tool)and then twist so they hold the
window in place.
13.Now test the window clips by pulling the top edge of the window away
from the firebox. The glass and frame should move freely and the
window clips should pull the window back into position. If they do not
then re-center the window or press it further down into the bottom
retainer until they do.
14.Turn on the gas supply.
15.Light the pilot and then the burner to be sure each functions properly. If
the flames do not appear normal, check the placement of the log set and
burner tile.
16.Install the front.Place the top clip up into position and swing the bottom
edge into position while lifting up on the front. Lower it down onto the
base.

We need your help! Woodstock Soapstone Co. takes pride in
providing the highest quality products as well as the best customer
service in our industry. We welcome your suggestions and input to
help us achieve these goals. If you have any comments to improve
our products, service, and information provided in these
instructions please contact us at [phone] or
[e-mail]. Thank you.
Revised 8/7/10