English version - 03/2015
AUDEMAT DVB-T/T2 Monitor Quick start notice
5. Select the “Network” menu in the same way.
6. Adjust network parameters one character at a time:
Select the character you wish to modify using the arrow keys.
Press the ‘’key to switch to edit mode.
Once in edit mode, use the arrow keys to adjust the value.
Press the ‘’ key to confirm the value before modifying the next character.
7. Once network configuration is done, press the ‘X’ key to return to the previous screen; you will
see a confirmation screen: confirm your new configuration with the ‘’ key.
You can now use the network cable to connect your AUDEMAT DVB-T/T2 Monitor to connect your unit
to the network.
3. Connecting to the network
Connect the Ethernet cable (A) from the unit’s primary
interface to your PC *, or to a router or a switch
* With a direct connection, you will need to set an IP
address on your PC in the same range as the IP address
you just set using the front panel application, so both are
compatible. Example: if the AUDEMAT Monitor’s IP address is 192.168.0.7, the PC IP address must be in
the 192.168.0.xx range. The procedure varies depending on
your operating system.
With Windows 2000 or Windows XP, go to:
Control panel / Network connection.
Local Area Connection / Properties
Click on Internet Protocol (TCP/IP) in the list then
on Properties.
Add the IP address and the sub-net mask. (for example
192.168.0.56 / Netmask 255.255.0.0).
With Windows Vista or Windows 7, go to:
Control panel / Network and Internet / Network and Sharing
Center.
Click on “View Status” for your local area connection, and on Properties
Click on Internet Protocol 4, then on Properties.
Add the IP address and the sub-net mask (for example 192.168.0.56 / Netmask 255.255.0.0).
