Worldlawn WY28S User manual

SCAN QR CODE TO VIEW OUR SETUP VIDEO
WY28S/32S WALK-BEHIND
BEGINNER MOWER ASSEMBLY/OPERATOR MANUAL

1
1. Tools to be used are shown above.
Utility Knife (Not Shown)
Wire cutters (Side Cutters)
Phillips or Flat head Screw Driver
3/8” Drive Ratchet
10mm Socket (3/8” Drive)
13mm Socket (3/8” Drive)
16mm Socket (3/8” Drive)
10mm Wrench
13mm Wrench
16mm Wrench (Not Shown)
Rubber Mallet

2
2. Place crate in open area for disassembly. If available use a rubber
mallet to help remove the top and side poles of crate as shown
below, right.
3. Using a Utility Knife carefully
remove the plastic covering and a tie down straps as shown below.

3
4. After plastic is removed locate Owner’s Manual that can be used
for any information you may need.
5. Remove rear bolt from frame as shown below.

4
6. Rotate handle into final position as shown above.
7. Install rear handle screws and nuts as shown, bottom left. Tighten
the 16mm nut & 13mm bolt as shown, bottom right.

5
8. Remove discharge chute and cardboard shown above.
9. Remove handle support bracket from front deck lift pins as shown
below. This can be discarded.

6
10. Locate drive lever rods and attach to left and right drive plates as
shown above.
11. Attach transmission rod and tighten nut with 10mm wrench as
shown below.

7
12. Attach blade engagement rod and tighten nut using 10mm
wrench as shown above.
13. Remove discharge chute fasteners from deck. Attach discharge
chute spring as shown below.

8
14. Install chute and spring and fasteners as shown above.
15. Using 16mm wrench and 16mm socket tighten fasteners as shown
below. The bolts should be snug, but loose enough to allow chute to
move.

9
16. On a level surface add SAE 30 oil to engine as shown above. Fill to
proper amount shown on dipstick. (Use engine oil specified in
Owner’s Manual.)
17. Add E10 or less Unleaded Gas to fuel tank as shown below. (Use
fuel specified in engine manual.) Make sure fuel valve is in ON
position when ready to start engine.